120

Hello i'm hoping someone could help me out with some vagcom logs. I have just got a Leon Cupra 1m, and have done some runs as although the car is fast higher up the rev range it doesn't feel so quick as the turbo starts up. It's a bit tricky for me to guage as i have only had the car a few...

Had a quick search but thought I'd ask for fresh advice. Had a spirited run down the by-pass earlier and my water temp shot up to 120 degrees, the warning light lit up and the alarm sounded. Eased off and the temp went straight back to 90 degrees. Drove through town stopping at traffic lights...

Big problem well not according to SEAT ALEXANDRIA PARADE [:@]GLASGOW.:censored: Well hears my stroy car has just had its water pump done belt and tensioner because i was getting high temp readings there for it was changed.:D Only for it to happen agian. So back to UNCLE ARNOLD it went...

While driving my car today(2003 Leon Cupra) i noticed the temperature gauge rising up past the 90 mark and it rose to 120 with a red flashing light and a beeping noise.i stopped the car and checked it over as best i could, signs of fluid leak, checked all fluids etc, but nothing.i rang my local...

fail bigtime. Limit values in parantheses: CO 0.7 (0.5) CO @ 2500rpm 1.0 (0.3) HC 181(100) LAMBDA 0.98 (0.97 - 1.03) So I went to my workshop where they had an old Audi A6 2,7Turbo cat laying around. Bolted it on and went back to the MOT center. CO 0.0 CO @ 2500rpm 0.0 HC 11...

Hi All, Just after a bit of guidance and or advice really. To explain; 5 minutes into a drive this afternoon (up to say 80 on a dual carriageway) the temp gauge hit 120 degrees, the warning alarm came on and then proceeded to fall back to 90 degress quite quickly. As soon as the buzzer...

anybody knows the 0 -120 mph times revo stage 1:rolleyes:

Hey guys, been playing with Vag-Com this week after my remap. Is the 120 block (Torque) at all right? It says I hit 338.9 @ 3k rpm? Seems alittle low IMO. Cheers Si