wastegate

Hi all New here, not new to Leon issues though. Hoping I can gain some insight to a long term issue I’ve had with my 2012 cr140 FR. I’ll try and keep it to the point. Car judders under boost after cold start. Idle is completely fine. Happens every time after I start driving from cold, and even...

Hi, Seat Ibiza 1.2 TSI. My car recently started entering limp mode randomly with both the EPC light and Engine Management Light appearing, went to my local garage to get it checked out and got the following code back : P334B00 - Boost Pressure Actuator - mechanical fault So, after having a...

Evening guys, First post,.. sad that it has to be for a continuing problem im having. Purchased a 55 plate Seat Leon FR 150bhp just over a month ago from a car supermarket in Hull. The car made it 3 hours down from Hull back to London when it went into limp mode with fuel pump relay and...

How I am going to connect greddy boost controler to External wastegate? Any picture of your projects will be helpful or links!

Is there anyway to check if my wastegate opens? I recently said about N75 being fitted the wrong way round and was wondering if the wastegate was ok? should i be able to open it by hand? Also what clutch is best to go for? I cant afford an upgrade yet, flywheel is costing 230 which is...

Hi all, got this weird noise between 3500/4000 rpm, ie when the boost kicks in on my car. Best described as ffttt ttt ttt tt ttt ttt t a bit like an old VW Beetle exhaust! Goes once thru this rev band and doesn't seem to affect the power delivery, dyno graph shows no glitches there either, nor...

Hello, For several years I had some problems with boost on my ibiza and i recently decided to try to solve them, but i need some help. My specs are revo stage 2 with all the stuff needed (4b fpr, larger downpipe, ...) and a forge FMIC. The most recurrent problem is a requested boost which is...

http://uk.youtube.com/watch?v=PA5T5PnWE-k&feature=related

Been offered a t3 t4 hybrid turbo and exhaust manifold, further to my split manifold. One question the new manifold and turbo setup comes with an external wastegate. will this work or would itbe easier to just blank the wastegate connection off. I am assuming no remap would be needed!?!

i have been wondering about this for a while now and was wondering if it would be possible to fit an external wastegate to my beeza, it has a vt2 turbo set up by allards and has a port on it with a blanking plate. my car boosts to 32psi and think a good quality wastegate would sound the nuts...

A mate has a 1998 1.8 20vt golf standard, when lifting of he gets wastegate chatter? Is that normal or is the a leak or a problem somewhere? Seems to pull alright and feels like it's boosting ok? Cheers...

Just experimenting (arsing about) with my engine today and I unplugged this pipe.... And the result was this wastegate chatter. Now I know this sounds very nice but is it healthy?!

i have a 1.9 tdi 110 that i had remapped to 160 bhp with uprated nozzels that am please with for now;) but it makes a louder dump than my mates cupra 1.8t but only since the remappe does anyone know why? or is it just because diesels are better;):D

Took my cupra in to a garage today for some diagnosis work as my engine management light had come on. Car had quite a few faults highlted including, excessive boost, boost exceeding maximum level, running lean and also a misfire (have never felt the car misfire and with me having only had it...

Took the car for mapping yesterday and the mappers had to end the session early as the car was hitting 22psi at 7000rpm on 2/3 throttle load with the wastegate fully open. The mappers were initially mapping the car N/A before going on to mapping it boosted. So, they disconnected the actuator...

can i change the setting of my wastegate actuator? like 0.1 bar or 0.2

ok got a bailey dv30 dirt cheap and fitted it to my lcr.ever since i have done this the wastegate chatters every now and again.is this cause the bailey uses a progressive rate spring which might be a bit stiffer??before i fitted it i tried pushing the piston inside the dv up and it seems alot...

As you all know i run an Apexi AVCR to control the boost on my car. It doesn't belong to me as i borrowed it from a friend while his car was off the road, its soon to be alive again and he will need it back. I cant afford to buy an apexi at the minute due more important things. What i...

Looking for brand new single port wastegate? Where to buy? Thanks.

The other week I went into SEAT to get the car looked at as I had an error code coming up on the dash. They fitted a new MAF as they said it was logging error codes. I cleaned the air filter the same day, and after all this work had been carried out I noticed a slight whistling noise from the...