SEATCUPRA.NET Forum merchandise
  • Hi Guest we, are working on an upgrade to the forum this week, meaning the service may be unreliable at times and there will be some planned downtime at some point. Stay updated on this thread.

  • Guest, 🚨New Stock alert: Premium CUPRA valve caps now available in the store 👉 Order now from the merchandise store

clutch pedal stuck!

supersticky

supersticky

Active Member
Dec 16, 2010
1,012
46
taunton somerset
Hi peeps, hope your night in is going well, popcorn film n females :) well mine ain't, I'm stuck at a petrol station atm, the problem is that when getting back in the motor my clutch pedel is stuck about an inch from the floor, I've popped into the garage n grabbed some WD and sprayed the pedel and the clutch cable bits n bobs in the engine bay with no effect! Also when lifting the pedel with my hand it just springs back to the floor!!! Any help would be great asap as this smell of fuels giving my a headache :(
 

Muttley

Catch that diesel!
Mar 17, 2006
4,987
31
North Kent
OK, my first guess was completely wrong :) And you've not got low fluid. Running out of ideas now. Is there anything in the footwell that wasn't there before - a spring or bits of metal? I'm wondering if the over-center pedal spring has broken somehow.

You've mentioned clutch cable bits in the engine bay - are you sure you have a cable clutch? Most of us have hydraulic clutch action...
 
Last edited:
supersticky

supersticky

Active Member
Dec 16, 2010
1,012
46
taunton somerset
O umm well there's spings with cables n stuff like that under the batt well behind it ish! :), anyway I sparyed all that crap, no mate no bits no metal, all clean under there. Btw what are all the springs n cables under the hood? Was it ok to spray um?
 

Muttley

Catch that diesel!
Mar 17, 2006
4,987
31
North Kent
I've had a good look and I can't find a Leon with a cable clutch. That's not to say you haven't got one, just that I can't find it.

The only springs and cables under the hood that I've seen are to do with the bonnet release. It's a good idea to spray them with lubricant to keep them working - every so often there are posts on here from guys who can't get their bonnets to open because the release has jammed. Lubricate it at every service interval with a spray oil or even just 3-in-one from a can - but not WD-40, which is good for chasing water away and releasing rusted fastenings, but is will dry up and go sticky - always flush out WD-40 with a proper lubricant if you free up a control system with it.
 

kinjamin

Black Altea XL 170
May 9, 2009
159
0
supersticky said:
ill take a piccy tomoz morning n show all the springs n cables.
Click to expand...

I had the same issue an inch from the floor! Could not change gear switch the engine off! However, I could pull the clutch pedal back. After looking to see if there had been any thing obstructing the pedal I found this see picture!

insuallation.jpg


This was stuck between the top where the hinge/spring was near the top of the metal shaft. Will test out the car tomorrow on route back to work but had a quick drive around the block and it all seemed fine. Lets hope that this was the issue.

Hope this helps

Kinjamin
 
ashtec

ashtec

Active Member
Oct 7, 2012
33
0
chandlers ford
I've seen a duel mass flywheel do that on a vw passat it was a very strange fault to find as it all worked fine and every now and then the pedal would stay near the floor.
 
You must log in or register to reply here.

Similar threads

Clutch pedal stuck on floor - low fluid?
Replies
10
Views
1K
SuperV8
SuperV8
Mysterious Clutch Problem
Replies
0
Views
366
Mallard
Jacobb5179
Failing Clutch?
Replies
4
Views
954
Jason2023
Dr1ve_everything_Da1ly
Clutch Information
Replies
0
Views
700
Dr1ve_everything_Da1ly
Dr1ve_everything_Da1ly
Clutch pedal sticking to the floor.
Replies
4
Views
2K
Karld1989
Nimbus hosting - Based solely in the UK.
Top Bottom