Fitting a strut brace

[Forbez]

Gonna fit the strut brace tomoz, but i've been thinking would it be better if i jacked the car up on both sides, taking the strain off the turrets/ suspension and then fitting it?

Or would the whole lot fall out if i did this and undid the bolts?

 

[Fl@pper]

leave it on the floor - if you dont move anything steering wise you should be able to crop it straight on

leave 1 bolt in each til the last minute

 

[Forbez]

Smashing cheers mate, I'll do it in the morning.

 

[Forbez]

Did it yesterday, luckily the new strut brace came with a nice bolt for the alarm to secure too.
Was a bit of a pain in the arse, to to as the brace was a very close fit to the bulkhead, where the rubber section runs along the top of the engine bay.

After a bit of force, and flexing of the muscles its all fitted, and is secure.

Seems to tighten up the front end nicely. Well worth the mod IMO.
Cheers Daz at Willoughby!