Fitting new Indicators in Wingmirrors - Cupra 280

[Deleted member 103408]

Guide now located in the new resources section of the site

Lighting - Fitting new Indicators in Wingmirrors

The following guide was created by a community member. The following is the steps I took to replace the indicators in my wing mirrors. In this case I have used Dynamic Indicators but the following steps are the same for Stock as well. Firstly...

www.seatcupra.net

 

[paddy6789]

I shall be using this when I get mine

 

[Deleted member 103408]

@paddy6789 this is starting to feel like you are stalking me, First i put on the rear spoiler and you copy (granted different one but never the less),
Then I fit this indicators and now you are doing that. hmmmm

 

[paddy6789]

If you keep writing the guides, I'll keep following them

 

[Deleted member 103408]

OK Well I have bought the stop start memory module which is my next job to fit so as you already have that one please dont follow

 

[paddy6789]

OK Well I have bought the stop start memory module which is my next job to fit so as you already have that one please dont follow

I'm going to attempt the blind spot assist mod at some point - I'll try and write up a guide as good as you.

 

[Deleted member 103408]

Just as a matter of interest dont you need extra sensors for that

 

[paddy6789]

Yeah, and wiring up a light that doesn't look obviously bolted on.

 

[Deleted member 103408]

excellent looking forward to it.

 

[Ben.Wylie]

Do you have videos of your new dynamic indicators fitted and working? I’m trying to find a set for myself but I can’t find them anywhere or from a trust worthy provider.