I can't remember straight away, but if you pop onto clublupo there are threads there that will tell you - I think there might even be one saved in the How To forum
You need to unclip the fascia where the dials are and then remove the small screws that hold the dials in. Just be careful when taking the fascia plate off as the clips can snap and make it difficuly to get back in. Might just be a dead bulb instead of a loose wire.
think its the wiring cause it keeps goin on and off. Was that for the mk 2 arosa or mk1? cause i know that the console is connected differently for them both,
The bulb has probably gone. You need a bulb (probably a W5 wedge bulb, 1.2W 12V)
Remove the front panel of the heater controls, and one of the control knobs, behind which is the bulb. Pull out the bulb (a piece of rubber tubing you can push over the bulb helps here). Replace and refit panel
still havnt sorted mine out yet. Mk 2 consoles are set out differently that the bulb is alot harder to get to. Still havnt been able to change mine Seat dealerships couldnt tell me how to change it either
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.