just purchased the eibach kit for £150 for front and rear so its a bargain
cant wait to get it now lol
Fitted the Fabia VRS front ARB today............
have to say, for £60 and at least an hourits a very worthy upgrade!
as the Sport ARB is 17 / 18mm and the VRS is 21mm, it's suprising the difference how much better it handles!
it has reduced the amount of roll by at least half if not more!
the front end feels so much more solid and planted which obviously increases confidence whilst cornering !
you do need to drop the subframe, but only about 20mm (ish) to lift the one end of the ARB over to get it out.
this is held on with 6 bolts, and the use of a trolley jack to support the subframe / engine
you will need a pal at the other endbecause its hard work threading the new ARB through.
not sure if it would be a noticable difference on a cupra but i can definately reccomend it for a sport!![]()
just purchased the eibach kit for £150 for front and rear so its a bargaincant wait to get it now lol
If the eibach kit has a front arb which is 23mm then it should give the cupra a similar improvement, as the std cupra one is only 20mm, so by going up to 23mm the increase in size is almost the same as a sport being fitted with a vrs arb!![]()

i have no idea about the thickness but i thought why not lol i wonder how much my insurance will go up due to this? lol
i assume its possible to just swap the rear? with regards to the front is it likely to cause any problems with the std seat strut brace?