• Hey Guest💡👉 We have just launched our new Dealer Directory and review service Find out more now
I have a jabba stage 2 map with the standard KO3. Its producing 205bhp and 323lbs of torque. I have a forge side mount intercooler, and a turbo back miltek exhaust with a 100 cell race cat

you got uprated rods or anything how they holding up...??

whats the delivery of the power like.?
 
nah its n standard internals at the min, but if i go for higher figures i will spend a large amount on rods tec lol. its much like a revo stage 1 in the sence that mine gives me absolutely everyting from 3k up to 5.5k-6k. Once its on boost (over 3k) its very smooth and pulls very hard in all gears. I tend to change gear at 4.5k so the revs stay neer the magical 3k lol
 
I have a jabba stage 2 map with the standard KO3. Its producing 205bhp and 323lbs of torque. I have a forge side mount intercooler, and a turbo back miltek exhaust with a 100 cell race cat

Thats an amazing torque figure better than most remapped tdi's, are you sure it isn't 323 Nm of torque instead of lb/ft?
 
On a standard motor you wouldnt get anything out of going stage 2...

but with the usual bolt on mods echaust filter fmic etc on a custom map id be wanting to see a bit more than only just hitting 200 bhp

just what revo say on there site 190-206 bhp on stage 1...


not strickly true
jabba custom map on my first cupra and all it had on was a jetex cat back green twister an forge tip

see for you self


jabbaremap001.jpg