Many of systems are not available after battery replacement

[unpleazant]

Hi everyone

Here is my problem:
I had to replace the battery (EFB) because previous just dead, but after that many of systems like ESC, ACC, Auto-Stop, tyre-pressure monitoring, front assist, parking assist and etc...all of them have "ERROR: ..... is not available". Ignition is working, I can drive. I also had tried to reset these errors via ELM adapters application - didnt help. Tried to reset all setting in car computer - didnt help.

Mb there is some solution before I go service?

 

[noidea]

How long did you drive for after you replaced the battery?
And did you programmed the battery specs with ODBEleven or anything? See: http://wiki.ross-tech.com/wiki/index.php/Battery_Replacement

 

[tracktoy]

if you are using OBD11 Then maybe this is a better link http://www.cupra280.co.uk/Battery Coding.html

 

[SteveGSXR600K1]

After changing the battery specs with OBD11, the main thing that got rid of most of the errors on the dash for me, apart from the 'Start-Stop', was to start the car and turn the steering wheel from lock to lock. A scan with OBD11 still shows the errors, so I just cleared them.

 

[RUM4MO]

I think that the OP's problem is the car's reaction to having a failed battery - and being unable to recover after fitting a new one.

I'd doubt, for this specific issue that any of the maybe needed, or desirable coding will have caused this, yes coding in a battery change is good, but this is a completely different problem/failure which was not expected to happen.

 

[Chris Bartram]

The steering angle sensors tend to get confused, usually a couple of lock-to-lock turns will clear it.