N112 Bypass

[Mat]

another stupid question, where do you get some of that heat shrink stuff from? Wilkos? B&Q?

 

[Damoegan]

That was a question, not a statement.
All mine hold boost (except the servo line that has a non-return). I've got clips on.

Ah, sorry Dave. Its been a verl long and hard week at work and I've had a few beers

I dont use and hose clips on my vac lines but I am using a smaller bore than you and there are a nice snug fit and take a little force to remove them.

 

[Damoegan]

another stupid question, where do you get some of that heat shrink stuff from? Wilkos? B&Q?

Yea, B&Q or RS. Ir you can wait till tuesday I can get you some from work mate.

 

[Mat]

yeah, I can wait. Cheers fella.

gotta order the vac lines and resistors. will order them 2moz.

cheers

 

[Damoegan]

I read you were after some silicone spray too. Pay the postage and I'll also stick some in the post mate

 

[Mat]

if it will protect the FMIC a bit/make it easier to clean, then why not

 

[Damoegan]

No probs mate. I'll PM you over the weekend for your address.

 

[Mat]

cheers fella

 

[Myki da Pyki]

Still in shock that you done this thread tho mat lol

 

[Mat]

ha ha

it's like an unwritten rule, regardless if it gets covered every week, there has to be a new thread for n249/n112/dv LMAO

 

[Myki da Pyki]

lol yeh true that

 

[Mat]

bloody typical! decided to do the N112 thingy ma-jig today, and can't find bloody resistors!!!

 

[Damoegan]

bloody typical! decided to do the N112 thingy ma-jig today, and can't find bloody resistors!!!

 

[kyle'87]

Get some pictures up of your loom once you put the resistors in dude

 

[GarryGti]

i done mine the other day. have a look on my progress thread to how i done it.

 

[__B3NNY__]

When i first started on here people always used to say either 3mm vac hose or 4mm with small zip ties.. I`ve always used 3mm with no problems that i know of?

 

[cuprachrissy]

always used 4mm with no ties and never had a problem (touch wood).

 

[Mat]

chaning all mine from 4mm to 3mm i think

 

[__B3NNY__]

I was just thinking, wouldnt it be better to go off the ID of what the pipe connects to?

I havent got my car at the moment, but for example if you look at the nipple on the DV im sure the ID is no bigger than 3mm?