Just got my car back today after it having spent 2 weeks in the garage with bad brakes. Turned out to be the master cylinder. Thats now been replaced. However, now i have no traction control of abs. I have "tried" both of them and they ain't kicking in at all. Any suggestions?
How would a coil pack cause that?
Ive been having a wee look about, is it possible that the abs pump maybe just needs bleeding? it def wasnt done as the garage it was in at doesnt have diagnostic equipment
No its not, go home and stop giving stupid advice!
It'll more than likely be the hub speed sensor, bout 60quid for the part and its a diy job, just on the inside of the hub behind the disc, give it a little clean and see if this helps, its just where the strut and the disc sit at there closest.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.