Noticed my 3"tip is a little squashed at the bottom

[ibizacupra]

LC is not LCR in fitment terms..
Every silicon tip I have fitted has always needed trimming down and the coolant lines in the way down there on k03 cars need "adjusting" slighly.. aka pull them a bit

 

[Deleted member 12147]

I fitted mine yesterday mine is the black version but you can see in the pic that the elbow that comes of the turbo has been cut virtually on the bend (this is how I got it, I didn't cut it myself). It was a tight fit because of the water/coolant lines at the side of the engine.

 

[newtimecupra]

thanks bill are they easy to move? and how much is safe to move them?

 

[Pyro]

No there a pain to move get sone lube out really helps

 

[cupra r. ash]

Iv done it now. I cut abit of both silicone bends. Still a tight fit but not squashed anymore, noticed a difference aswell

 

[MasserS]

Sounds painful!

 

[Pyro]

??????????????????

 

[KatCowie]

I had to cut my Badger5 TIP down too, mine is red also. As said above, better to be a bit too long, than too short. Just cut a little off at a time, until you find it's a good fit.