-
Guest, 🎅🎄Looking for a stocking filler idea? Why not treat yourself or a loved one to our high quality CUPRA or SEAT valve caps. Order now from the merchandise store
The correct way to do an N249 bypass the full guide
- Thread starter mc funbot
- Start date
Get pics up guys
Did this over the weekend as per your instruction Funbot, took no more then 30mins. Thanks very much!
I would put a picture on just so it could be confirmed iv done it correctly but it wont let me at the moment! Thanks again for the guide!
Completed this mod today,running sweet...
Found this while i was in there and fitted my new SFS breather.
Found this while i was in there and fitted my new SFS breather.
Is the flutter from the DV normal, I got this after doing this I have a forge 008. Its only on light boost letting off that it does it once I belt it and put the foot down the DV just works normally.
I very occasionally hear light flutter on low boost (too be honest, its few and far between) and im also running the 008 with cone filter. Full boost it doesnt do it, so i think its ok. From what iv read, if you get chatter coming off full boost, thats bad as its the compressor stalling.
Should be fine I imagine. Always could get it checked by reliable mechanic(s) for 2nd or 3rd opinion. Thats what I did.
I will get round to an SAI removals when I get some time. I've had a little noise it all seems ok everything working fine and all is good.new services 007 the same
Yes mate it's not hard just need a blanking plate some cutters and 5mm Alan key 8mm Alan key 10mm spanner if I get some time ill get something done
if I get some time ill get something done 
Hi,
Great pics and guide, just a quick question though, in picture 15, which shows the two rubber pipes removed, do you blank them off? Maybe I missed something and having a thick moment? And when I refit the resistors, do I leave them open?
Great pics and guide, just a quick question though, in picture 15, which shows the two rubber pipes removed, do you blank them off? Maybe I missed something and having a thick moment? And when I refit the resistors, do I leave them open?
Last edited:
dazz74
Guest
Is this for the auq engine. Where you cut the three rubber pipes where they come off the 249 valve one I've mine is a small braided like hose :s. all your 3 pipes look the same size
Similar threads
