scottyA
Guest
I've got a stage 2 Cupra 1.8T.
Two nights ago I went to plant my foot and was met by a rough juddering noise at about 0.75 bar. Shortly after a coil pack went on me ( due to a service earlier on in the week thought I might have upset the coil)
So I replaced the coil pack and it still judders anything after 0.75 seems to keep boosting but slowly and making this noise. Had a gas generator put on there today with no leaks bar a bolt hole in the head between the middle cylinders?
The garage said to give it a good rev then switch It off to see if the turbo bearings had gone but all sounded fine. What's the possibility of it being the turbo actuator and do I go and buy a forge one but have it set up properly on a rolling road?
I'm stumped now as i don't really wan to drag it all apart to test the actuator with no real advice on any other problems that could cause it.
Any help would be much appreciated
Alex
Two nights ago I went to plant my foot and was met by a rough juddering noise at about 0.75 bar. Shortly after a coil pack went on me ( due to a service earlier on in the week thought I might have upset the coil)
So I replaced the coil pack and it still judders anything after 0.75 seems to keep boosting but slowly and making this noise. Had a gas generator put on there today with no leaks bar a bolt hole in the head between the middle cylinders?
The garage said to give it a good rev then switch It off to see if the turbo bearings had gone but all sounded fine. What's the possibility of it being the turbo actuator and do I go and buy a forge one but have it set up properly on a rolling road?
I'm stumped now as i don't really wan to drag it all apart to test the actuator with no real advice on any other problems that could cause it.
Any help would be much appreciated
Alex