vacuum hose

[andyc58]

Hi ive looked loads on this on here and cant find it.I want to do the n249 bypass but not sure what size vacum hose i need and where to get it from.Any help would be great.Thanks

 

[adam cupra 20vt]

I used 4mm ID silicon and a 6mm T piece.

 

[andyc58]

were did u get the stuff from

 

[adam cupra 20vt]

Silicon Hoses Direct via Ebay

 

[rsmith]

Hi ive looked loads on this on here and cant find it.I want to do the n249 bypass but not sure what size vacum hose i need and where to get it from.Any help would be great.Thanks

Wow, surprised you didn't find anything
try a search for N249 an you shall find tons.

http://www.seatcupra.net/forums/showthread.php?t=215866
http://www.seatcupra.net/forums/showthread.php?p=2683065#post2683065

 

[SalSheikh]

I used 4mm ID silicon and a 6mm T piece.

adam, what was the 6mm t-piece used for?

been looking at various threads but cant see where the t-piece is needed

 

[Mr OCD]

adam, what was the 6mm t-piece used for?

been looking at various threads but cant see where the t-piece is needed

To connect the DV into the inlet manifold vacuum.

As been said there are loads of threads on here about it.

 

[SalSheikh]

right, looking at the threads again, this is my understanding of it:

DV 4mm tubing > t-piece > inlet manifold/boost gauge

 

[adam cupra 20vt]

right, looking at the threads again, this is my understanding of it:

DV 4mm tubing > t-piece > inlet manifold/boost gauge

If you want to run a gauge and n249 bypass from the FPR hose you want a 4 way T