Wheel Spacers
- Thread starter DarrenJ
- Start date
stonechip1
Guest
I've read a bit about the delta mic spacers and seemingly the bolts that are supplied with them and very soft and can shear off if over tightened and can even come loose. Is it possible to buy stronger bolts to replace them with???
Ok just to add a few points to this thread.
You can run 20mm on the rear on a low car (as I have done) BUT don't be fooled into thinking you can buy 20mm spacers on eBay with the bolts. Why? Cos I did too, came with bolts, but most are normal bolts. You will need radius bolts. My radius bolts cost a further £22 for 10.
DO NOT fit a spacer without radius bolts.
The car looks better, handles alot better, and I suppose it will help braking stability too (not yet tried that). Just remember to re torque the bolts after a few days as they WILL get looser.
Sent from my iPhone when I should be working....
You can run 20mm on the rear on a low car (as I have done) BUT don't be fooled into thinking you can buy 20mm spacers on eBay with the bolts. Why? Cos I did too, came with bolts, but most are normal bolts. You will need radius bolts. My radius bolts cost a further £22 for 10.
DO NOT fit a spacer without radius bolts.
The car looks better, handles alot better, and I suppose it will help braking stability too (not yet tried that). Just remember to re torque the bolts after a few days as they WILL get looser.
Sent from my iPhone when I should be working....
The delta mics aint off eBay so hopefully they'll be fine. There is a menu for different makes of car so it looks like the LCR versions are spot on.
Also will fitting spacers knock out the tracking or alignment????
Also will fitting spacers knock out the tracking or alignment????
Last edited:
Dolby - you mention about radius bolts, where is best to buy a set of extended locking wheel nuts?
Similar threads
