where to route afr gauge?

[gazcuprablk]

where is the easiest place to route the afr wires as theres a big connector that looks a bit big to push through any of the grommets i want to mount it up in the pod which is on the pillar? how have you done yours?

cheers gaz

 

[ibizacupra]

behind the wiper motor in the scuttle, there is a large blank grommet which would take the connector

 

[DaNnY_LaD]

behind the wiper motor in the scuttle, there is a large blank grommet which would take the connector

what Bill says...

Then Run the Wires Down behind the dash...

Keep the Controller as dry as possible tho....

 

[gazcuprablk]

all done now it idles at 14.6-14.9 is that ok?

 

[rudolf2]

Yes that is ok, mine idles the same.

 

[DaNnY_LaD]

Gte the software u got with it and put it on a laptop to smooth the signal out....Ive done that and it does jump about as much

 

[ibizacupra]

personally I would'nt slug the readout.... leave it be... you want to see things work quickly to catch lean event, not a smoothed slower to respond readout when its too late

 

[DaNnY_LaD]

personally I would'nt slug the readout.... leave it be... you want to see things work quickly to catch lean event, not a smoothed slower to respond readout when its too late

Yup.

hence why i used the software supplied...

 

[PhilW]

Yup.

hence why i used the software supplied...

I dont think you understood bill as usual.

 

[h17och]

^^lol

 

[__B3NNY__]