-
Guest, 🚨New Stock alert: Premium CUPRA valve caps now available in the store 👉 Order now from the merchandise store
What did you and your MK2 do today?
- Thread starter Tfsi_Mike
- Start date
Got wet and coated in AB Project 32
Not the best photo but it's locked away inside the garage.
Sent from my iPad using Tapatalk
Not the best photo but it's locked away inside the garage.
Sent from my iPad using Tapatalk
Its a house hold cleaner/stain remover comes in different forms. Its about 4 quid in Robert days and some supermarkets have it. Cleans through grease, dirt,everything really. Used it recently when I had large water stains on my scuttle panel and took them off straight away. I even use it on my exhausts brings them up nice. You tube it
Last edited:
Quoted without the pics this time
I had the exact same on my black mk2 last week, clay mitt had them gone soon enough. They wouldnt even pick off with my fingernail.
Tried everything i had initially, tardis,iron x, SRP, and more.
Not a clue what the cause was.
I got small splats of green paint on my old MK1 Leon. I'm convinced in came off the back of a decorators / builders van I went past. It won't take much more than a paint tin with fresh paint on the lid / down the side for it to form 1000's of small drops while on the road!
It took me weeks doing a small area at a time with a clay bar to get it all sorted!
Played around with a fix for the leaky scuttle, i had the idea some time ago.
On a crude install, it worked quite well. More info soon.
Also dismantled my failed dectane DRLs to repair a snapped wire, had to go through the front and back of the unit. Connected all up to test and had a cracked LED making three others strobe due to my clumsiness. Now have the job to match and replace a single LED.
No fun at all
On a crude install, it worked quite well. More info soon.
Also dismantled my failed dectane DRLs to repair a snapped wire, had to go through the front and back of the unit. Connected all up to test and had a cracked LED making three others strobe due to my clumsiness. Now have the job to match and replace a single LED.
No fun at all
Last edited:
sam how was the rs4 valve in fitting ive got one here but looks in a right pain in the (finger) arse haha
It was a horrible job as I did it with the inlet manifold still on. Modified spanner and all sorts. Then smacked finger with a hammer so hard it split open lol. Was trying to bend a spanner over a kerb and some how missed. Strange as I'm a carpenter and normally pretty good with a hammer.
Last edited:
Vinyl wrap to Triple R
Finally got round to wrapping my front splitter as didn't want the gloss finish.Hopefully fitting Wed
[/URL][/IMG]
[/URL][/IMG]
Finally got round to wrapping my front splitter as didn't want the gloss finish.Hopefully fitting Wed
Looks good mate. Did you find it hard? I want to do this but in red carbon fibreFinally got round to wrapping my front splitter as didn't want the gloss finish.Hopefully fitting Wed[/URL][/IMG][/URL][/IMG]
It's for Stage2+ extreme
the valve allows for more fuel pressure, another 10bar over hpfp, more midrange and over 400ftlb.
No wasn't to bad bit tricky in two points at the front but was my first attempt and happy once i folded wrap underneath i applied fibreglass matt and resin to make sure it never pulls back
It's for Stage2+ extreme
sounds good to me.
Similar threads
