OBDeleven modifications

[Zer0]

Yes, there was an entry in control unit 13 long coding that I didn't think it was related.
Later found out that it was, and changing it solved the problem and it worked.
(Position_sensitive_detector : not installed --> installed)

Would it be possible to code Predictive ACC on your own using only OBDEleven long coding and adaptation? I read somewhere you needs to update the camera module software in some way as well but not sure if it's true or not but the hardware is there already. I do have the hardware required already as far as I can tell (lane assist, normal ACC, camera for detecting speed signs and so on).

And I have OBDEleven Pro and know how to do long coding. Any advice would be great.

 

[serdar_18fr]

Would it be possible to code Predictive ACC on your own using only OBDEleven long coding and adaptation? I read somewhere you needs to update the camera module software in some way as well but not sure if it's true or not but the hardware is there already. I do have the hardware required already as far as I can tell (lane assist, normal ACC, camera for detecting speed signs and so on).

And I have OBDEleven Pro and know how to do long coding. Any advice would be great.

As far as I can remember from the time I was haggling with it, first thing you need to do is to replace the radar (control unit 13) firmware with the patched one (step 1) so it would accept the made-up swap codes. Then you need to create the swap codes (step 2) and upload it to the radar (step 3) and finally do the required coding changes (step 4).

Small utility apps are available for step 2. You can perform the steps 3-4 using OBD11, but not 1. You would need ODIS, VCP or VCTool for that.