needle

Does anyone have the speedo dial matt's and needles off a LCR or any similar model that they dont want, im wanting to swap the matt's on my s3's speedo other, bit board of the one's on now.

Fitted my boost gauge and it shakes like mad on tick over makes a wierd noise sometimes, Read on here about the special t pieces for this, But mines a diesel so it plumbed into the plastic boost pipe. How can i stop it??

Before i carried out work on my ibiza (before christmas) the coolant would reach the middle which i guess is 90° pretty sharpish nearly before my oil would show a mfa reading (50°). These days however i can drive 20 miles without the needle reaching the middle, the oil will happily show 78° on a...

Ok plugged my laptop into the car today to play a bit if fault code bingo and to my surprise I'm down to one code now, 17655 - needle lift sensor (g80): open or short to plus. Simple question really - what's that mean then?

after nearly 18 months with my car the temperature gauge has never ever gone above dead centre, today i was driving down the motorway and it crept to the next line! i checked the water and for any obvious leaks but al seemed fine, turned the engine back on and it sat back at dead centre...

hi, i need some advice on what the problem on my cupra could be... Was driving along the other day and all of a sudden the temperature needle shot up into the red and the redlight came on and started beeping. I thought it was loozing water at first but i couldnt see anything leaking. I...

Driving home yesterday - was on the motorway doing about 70 - had to slow down to 50(bloody m1 road works[:@]) and noticed my temp need drop considerably - just above the first quarter mark - then went up to 70MPH again and went back to 90 degrees stood in some traffic, it dropped again...

I've just got a new job and it involves a longer commute, and since last week I've noticed a little problem. (I've done a search but would like some suggestions as nothing seems to match my situation) I start the car and get no beeps from the coolant level sensor or anything (I have had it...

as it says my boost gauge needle flickers/quivers when it peeks any idears y? ive put a brand new MAF & n75valve on but it still dos it.............. please help:help:

Just bin in my car and had a brain wave!!! Would it be possible to use the petrol gauge needle and put that on an autometer boost gauge???? I'm not to keen on the orange needle so this would make it look a lot more like the other gauges/clocks. This is just an idea, so if it's not...

just fitted my tim boost gauge as per the guide in the styling section and have noticed that the needle is rather shakey any ideas on what may be causing this.Also i only have two wires on red and black where will these wire go on the wiring in the light switch.