-
Guest, New Stock alert: Premium CUPRA valve caps now available in the store ? Order now from the merchandise store
Alloy wheel refurb guide
- Thread starter adam cupra 20vt
- Start date
I can add some picture of stages of top coat in a few days if wanted
Is using chemical metal better than using etec alloy wheel puttie ??
Or do u get the same finish from both ? Ive always used puttie before in the past and found it to be easy to work with so was just wanting to know if you find the chemical metal has a better and longer lasting result ?
I have not heard of wheel puttie.
Chemical metal is easy to work with and easily obtainable by everyone so I used it for the guide
I have not heard of wheel puttie.
Chemical metal is easy to work with and easily obtainable by everyone so I used it for the guide
What brand did you use and i will give it a go
I found these which look handy instead of masking off the tyre
http://www.wheelpaints.co.uk/Sundry-Materials/Masking/Spray-Out/Wheel-Mask-Cards.Html
http://www.wheelpaints.co.uk/Sundry-Materials/Masking/Spray-Out/Wheel-Mask-Cards.Html
I did my wheels recently with the Wurth Paint. Have to say it is really easy to do and best done over a period of time so you don't rush it or get tempted to spray the paint too thick. My advice would be keep the coats of colour thin and consistent and you won't get runs.
If you want the faces to be nice and flat do a lot of sanding and prep work!
If you want the faces to be nice and flat do a lot of sanding and prep work!
Can i ask what materials you used? what colour Wurth paint did you use? and do you have any pictures of the finished wheels.
Sorry about the picture quality but hopefully you can get the idea of the colour match. That is a during and finished shot.
If you google or search ebay and Amazon for Seat Wheel Paint or VW alloy paint it should come up. I bought the base coat and lacquer. If you can't find it let me know!
[/URL][/IMG]
[/URL][/IMG]
[/URL][/IMG]
Sorry about the picture quality but hopefully you can get the idea of the colour match. That is a during and finished shot.
If you google or search ebay and Amazon for Seat Wheel Paint or VW alloy paint it should come up. I bought the base coat and lacquer. If you can't find it let me know!
http://www.ebay.co.uk/itm/like/1906...ICEP3.0.0-L&ff14=122&viphx=1&ops=true&ff13=80
This is the paint I bought, you can get it cheaper if you look around. I forgot to mention you would need a primer. Most recommend an etch primer and I also bought the Halfords project pack of sand paper.
If you have considered doing a colour change on your alloys I'd say go for it. If you take your time I would say it is fairly easy. I'm going round mine and doing them 1 by 1 as I don't have a drive to leave the car on axel stands. For a repair job it is pretty easy do just take your time.
A question for anyone. Ive recently got a set of DRC DMG alloys which are polished and gun metal. Girlfriend has managed to very slightly kerb one of these so it has a bit of a "rash" on the lip. Given they're brand new and it's not too noticeable I was going to gradually sand it out and use some slightly abrasive aluminum (mothers mag and aluminum) polish to lessen or even fix it.
What I'm not sure about though - are these finished in a clear laquer (guessing they will be) and if so what type or clear laquer would I need.
What I'm not sure about though - are these finished in a clear laquer (guessing they will be) and if so what type or clear laquer would I need.
Similar threads
