Cupra pulling away problem

[mainaman]

It happened this afternoon.The car starts normally,but after you try to pull away,it doesn't apply throtle immediately,then it lurches really fast forward then it stops,grinding noises bellow.Like the handbrake is applying itself...

After several attempts and restarting,i put it into manual and it went smoothly and i could drive without problems.Change to D again and the car was driving fine again.

What has happened,why the car couldn't pull away before that

The problem persisted during my first week of ownership,then disappeared-just after a trip to the dealer,who didn't find nothing wrong!

 

[techie]

Don't sound good, best get it looked at.

 

[mainaman]

Don't sound good, best get it looked at.

Yeah,i will have to go to the dealer.Too bad,first day and problems already

 

[mainaman]

The same problem this morning,doing reverse had the same effect as well.

In ten minute the car pulls away fine in any mode.Calling the dealer today

 

[GPL]

Any updates on this problem??

 

[jc_boc]

Yeah mate, that don't sound right.

 

[CupraDean]

wow this dont sounds good. get it checked for sure!

 

[mainaman]

Oh,this problem just disappeared after the first week and never happened again after that!
Very strange and very worrying at the time...

 

[GPL]

Thankyou.

 

[dan_wilson87]

were u flooring it by any chance? if so then it would have been the esp/traction

 

[mainaman]

were u flooring it by any chance? if so then it would have been the esp/traction

No,it wasn't that.

 

[Klang J]

this sort of happens to mine. but without the grinding. its almost impossible to set of slow

 

[Hank]

It wouldn't be hill hold control kicking in would it?