![[:@]](/forums/styles/seatcupra/oldforumsmileys/furious.gif "Furious [:@]")
I'm back home tomorrow hopefully...... Then off to france to play in the powder on sat morning
I'll be back on the 31st, doing the flat first......
-
Guest, 🚨New Stock alert: Premium CUPRA valve caps now available in the store 👉 Order now from the merchandise store
I'm back home tomorrow hopefully...... Then off to france to play in the powder on sat morning
I'll be back on the 31st, doing the flat first......
I always say it, but I'd defo get a red cupra if I were to change mine! How much did it cost to get the vent in the wing Baz? I need to replace mine and was thinking on similar lines?
Not sure mate, got a load of other stuff done at the same time. But i was told that it's a pain in the hoop to do. The vent itself is straight and wing is curved so there's a fair amount of work getting it right
A few more bits and pieces for the TO BE FITTED list.
New water/methanol tank
New top mounts Front & Rear, front wishbone lower.
Sparco subframes
New water/methanol tank
New top mounts Front & Rear, front wishbone lower.
Sparco subframes
Last edited:
FECK canna see then, BAM NOGGIE FIREWALLS!!!!!
What are they Barry? and will they be fitted to the car or propping the bed up.........further, lol
What are they Barry? and will they be fitted to the car or propping the bed up.........further, lol
Ibiza 130 tdi, cheers mate. Although i may have to loose the gauge pod on the A-pillar because of the cage.
Beattie, Not yet. I'm going to go for a bolt in cage either OMP or Sparco i think.
where can i get hold of a bolt in cage???
As far as i know they work with all ecu's but they definitely work with ours.
Going to send my ko3s to CR-Turbo's to get the hybrid treatment.
any idear how much that would cost as i would like to send my ko3s there when it turns up?
JS, nae luck I've labelled up now.
Peachy, the only places i've found so far are Rallynuts and Demon Tweaks but both are for the mk2 but everyone says they'll fit the mk3. If it doesn't fit i'll make it!!
CR-Turbo's offer a couple of options for the hybrid ko3/s etc but for the up to 300hp version it's around £600.
I've labelled up now.Peachy, the only places i've found so far are Rallynuts and Demon Tweaks but both are for the mk2 but everyone says they'll fit the mk3. If it doesn't fit i'll make it!!
CR-Turbo's offer a couple of options for the hybrid ko3/s etc but for the up to 300hp version it's around £600.
Last edited:
JS, nae luck
Peachy, the only places i've found so far are Rallynuts and Demon Tweaks but both are for the mk2 but everyone says they'll fit the mk3. If it doesn't fit i'll make it!!
CR-Turbo's offer a couple of options for the hybrid ko3/s etc but for the up to 300hp version it's around £600.
Baz - That is a bargain. Get it ordered min, and when it arrives, put it in to the still to be fitted pile
JS, nae luck
Peachy, the only places i've found so far are Rallynuts and Demon Tweaks but both are for the mk2 but everyone says they'll fit the mk3. If it doesn't fit i'll make it!!
CR-Turbo's offer a couple of options for the hybrid ko3/s etc but for the up to 300hp version it's around £600.
£600 i was thinking more along the £400 mark just want abit over 250bhp
I'd say £600 is alot of money but 300BHP is asking alot of a KO3s so its fair enough really.
Have they confirmed that this will 100% give you 300BHP?
Dam feck Noggie firewalls, canna see that anes either.
Take it its tyres for the tractor? lol
Have they confirmed that this will 100% give you 300BHP?
Dam feck Noggie firewalls, canna see that anes either.
Take it its tyres for the tractor? lol
From memory i'm pretty sure they do a complete rebuild with the addition of a larger turbine wheel for £450 which will make 250.
I'll be happy if it makes over 285bhp but as long as it still spools quick for sprints and hillclimbs.
I'm looking at roughly £1500 all in. But these tyres were'nae cheap so that's dented the fund some what
Turbo -600
Unichip - 600
BAM Injectors - 80
BAM Fuel Pump - 40
BAM MAF Tube - 30
Baz special DIY TIP. 40 plus oil, gaskets
Yip new tractor tyres! Very impressed!!
I'll be happy if it makes over 285bhp but as long as it still spools quick for sprints and hillclimbs.
I'm looking at roughly £1500 all in. But these tyres were'nae cheap so that's dented the fund some what
Turbo -600
Unichip - 600
BAM Injectors - 80
BAM Fuel Pump - 40
BAM MAF Tube - 30
Baz special DIY TIP.
40 plus oil, gasketsYip new tractor tyres! Very impressed!!
Last edited:
Looks good baz, your the man in the know,
if i get my new job i'm intending on the same lines as you, with what allen was saying.
Sounds fleet.
if i get my new job i'm intending on the same lines as you, with what allen was saying.
Sounds fleet.
From memory i'm pretty sure they do a complete rebuild with the addition of a larger turbine wheel for £450 which will make 250.
I'll be happy if it makes over 285bhp but as long as it still spools quick for sprints and hillclimbs.
I'm looking at roughly £1500 all in. But these tyres were'nae cheap so that's dented the fund some what
Turbo -600
Unichip - 600
BAM Injectors - 80
BAM Fuel Pump - 40
BAM MAF Tube - 30
Baz special DIY TIP.
Yip new tractor tyres! Very impressed!!
yea id do it for 450....would you change the manifold as well
Just a wee update. My cage, seats and baffled sump(cheers Rob) have all arrived and just my luck they all turned up a few days after I came back to work.
No pics yet for obvious reasons but i'll get some taken when i get back.
Made a wee bit of progress when i was home. Relocated the wmi pump to the spare wheel well and fitted the new tank. Also wired up an arming switch for the wmi along with toggle switches for the electric windows. Oh and I ripped out the aircon and fitted my new horns.
No pics yet for obvious reasons but i'll get some taken when i get back.
Made a wee bit of progress when i was home. Relocated the wmi pump to the spare wheel well and fitted the new tank. Also wired up an arming switch for the wmi along with toggle switches for the electric windows. Oh and I ripped out the aircon and fitted my new horns.
Similar threads
