Ecu cover , any one interested

[nick-barnes07]

Is the ECU on the Mk2 located the same way/ same place as the Mk3?

If so might be some interest from me!

check under the skuttle panel , where the wiper blades go into , if its under there then yes it is in the same place

 

[C11PRA DC]

Yes I know where its - lol

Just was'nt shure if there are subtle differences in its location/mounting for the Mk3 , which would come into play if using existing mountings etc to secure the new cover!

 

[ForgeMotorsport]

guys ....we could be on with this if you sent us a drawing ....let us no what you want and we can start looking

 

[PhilW]

I'll try and do it lunch time today.

 

[nick-barnes07]

come on guys , my poor ecu is getting wet , need one of these asap .

 

[PhilW]

I've sketched it up now, just gotta chuck it on a drawing now for the boys @ Forge.

 

[ForgeMotorsport]

good on ya Phil !! ;-)

 

[Havok316]

im defo interested. Protecting my revo

 

[ForgeMotorsport]

any news

 

[Funkyfin2000]

come on now

 

[nick-barnes07]

any drawings yet philw

 

[__B3NNY__]

Hope its going to have a nice pressed in forge logo on it, even though you cant see it would look pretty cool.


David.

 

[Fl@pper]

wrapping em doesn't work for long as they sweat

along with the cover I'd recommend raising it too as sitting so low is the main problem

 

[__B3NNY__]

Or the forge logo cut into the sides for ventilation obviously not to big othewise you would be back to square one with the water issue!


David.

 

[h17och]

the amount of money it would cost to have writing cut in to it and you wouldnt even see it...no point!

lets keep it cheap ay!

any luck yet philW?

 

[__B3NNY__]

i know you wouldnt see, but was just a thought for ventilation. , Its gotta have the forge brand on it somwhere i guess?


David.

 

[h17och]

probly just their stamp if anything

 

[__B3NNY__]

like what was said above its possible for them to sweat so its gunna need ventilation? drilled holes would look shabby IMO?

David.

 

[pj1985]

They could spray Forge on it instead of stamping or cutting.

Does need ventilation aswell but how do you do that without leaving a gap for water to enter?

 

[h17och]

but if its a 5sided box there will be plenty of ventilation! im sure we said it was a 5sided box...no?