Forge bov

[mardon]

I have one not being used which i'm happy to sell. PM me if interested.

That bottom bolt is a pain in the ass, just have patience and a short allen key.

 

[CupraDean]

Sayyy what I got the spacer yet no destructions. I believe this could be a fml situation.

 

[CupraDean]

Anyone give me an idea of where I'm putting this

 

[CupraDean]

Anyone bit of help?

 

[splinter26]

I'll take a picture for you in a bit fella

 

[CupraDean]

Cheers bud!

 

[CupraDean]

I have found the instructions on the forge site, but the pictures don't seem to be loading :s

 

[splinter26]

I'll run down and do it now fella

 

[VRSLOZ]

Did you see THIS mate?

 

[splinter26]

Can just about see it here just above the left hand side of the turbo heatsheild:

 

[CupraDean]

Ahh yes I see her now! Thanks bud.

 

[CupraDean]

And yes that's what I'm on about, the pictures don't load up for me. Sc16v

 

[splinter26]

No worries good luck!

 

[CupraDean]

Splinter what you sprayed your heatshield with? Looks mint!

 

[splinter26]

When i bought the car it had another heatsheild on it that had started to flake, Ross had a spare that iirc he had primed by a bodyshop with heatproof primer. This was applied by brush hence the brush strokes. I then bought some hamerite black barbecue paint from halfrauds which is heat resistant up to 600C then got some heat proof engine primer off of amazon (one layer of each of the latter) and done

 

[CupraDean]

Ah awesome, may get my mate to sort ne out with heat resistant primer

 

[splinter26]

Relatively cheap mod, but makes a huge difference in the engine bay

 

[CupraDean]

ok im confused, mine has like 3 places for screws? and this is showing 2?

 

[Deleted member 55317]

must be looking at the wrong bit ive had a scout round my engine bay before my bov arrives and mines defo only got 2 screws

 

[Deleted member 55317]

OMFG!!!!!!!!!! what a faf to fit thats bloody thing!!! got it done in the end but that bottom bolt is a sh!ter to get out!! then ...back in ahhhh....but worth it and just requires a lot of patience