Soopacoop Lcr rota grid drifts , ksport 8pots ,stripped and caged
- Thread starter Murdered LCR
- Start date
Let's pretend you didn't put that up Wayne that's gash lol
Want this one so if some one can find out where I will love you forever
Tom wish I could get the mani on but I can't and don't think nicks about ,
Also don't even know if I'm going to the rr day just been told I'm going to see labyrinth the same night
Want this one so if some one can find out where I will love you forever
Tom wish I could get the mani on but I can't and don't think nicks about ,
Also don't even know if I'm going to the rr day just been told I'm going to see labyrinth the same night
No you big gay lol I've found the seller I've messaged him waiting on a reply will see what he says
Got more little bits to do on the weekend change the thermostat again as the one I replaced was broken so ordered a neuspeed one from awesome gti , I have the wmi solenoid to fit and wire up a red led to the float switch for the tank , all the wires are run so wont take long , I've decided against keeping the wmi controller in the ash tray so I'm going to remove the ash try and have a sheet of carbon fiber with the controler inside and the red led warning light so it's on display to give me enough warning , I can still hide bits behind it and still get to the obd port , also have the new turbosmart dv to fit and test , then I can test the wmi out to see what gains i can gain
Fitted my carbon bonnet today 
let me know what you all think ???? Needs a little adjustment and spacing on the drivers side but other than that it's all good my aero catches lined up a treat ,
Also fitted my turbosmart dv but its going to take a while to set up correct , started to take the climate control out to measure up the carbon sheet , will start on it tomorrow tho shouldn't be to long then I can go for a drive to test the wmi
let me know what you all think ???? Needs a little adjustment and spacing on the drivers side but other than that it's all good my aero catches lined up a treat , Also fitted my turbosmart dv but its going to take a while to set up correct , started to take the climate control out to measure up the carbon sheet , will start on it tomorrow tho
shouldn't be to long then I can go for a drive to test the wmi
Can look good but requires arches modifying to get any kind of fitment. Back to the drawing board, i'm too tight to pay for it haha
![[B)]](/forums/styles/seatcupra/oldforumsmileys/shades.gif "Cool [B)]")
Similar threads
