So I’ve managed to get a large port SEM manifold that I’m looking to fit to my LCR but I need an adapter plate. However I was wondering has anyone swapped their 65mm throttle body to a 75mm or even 80mm? If so what did you use?
The point of the inlet was to get better flow with the intention of modifying the head and TB at a later date (finds available). But I’m thinking why buy two adapters when I can get one for a 75mm TB and swap them both at a later date. I’m assuming I will need to swap my IC pipe as well to accommodate the larger size.
Sent from my iPhone using Tapatalk
The point of the inlet was to get better flow with the intention of modifying the head and TB at a later date (finds available). But I’m thinking why buy two adapters when I can get one for a 75mm TB and swap them both at a later date. I’m assuming I will need to swap my IC pipe as well to accommodate the larger size.
Sent from my iPhone using Tapatalk
