Does anyone have a standard ride height 2.0 16v?

[Icecavern]

As title, does anyone have a 2.0 16v SX that's on standard suspension settup?

I'm after some measurements

Pete

 

[Icecavern]

No-one?

 

[cordobabrendy]

maybe youre not getting the coverage in here pete, have you tried the leon section?
What are you trying to figure out?

 

[Icecavern]

maybe youre not getting the coverage in here pete, have you tried the leon section?
What are you trying to figure out?

lol @ Leon section comment... ( Although you're probably right )

I want some measurement to be able to figure out how much I've lowered mine by.

 

[myseatcupra]

i wish i could help. but mine lowered. i think hehe

 

[Cupra Kid]

mines not lowered (to my knowledge) i'll help if i can

 

[Icecavern]

Nice one

What I need is the measurement from the edge of the wheel arch to the center of the wheel at the front and back wheels. Then I can compare that with mine to see how much it's lowered by

 

[Cupra Kid]

edge of the wheel arch to the centre of the wheel is 35cm on both the front and back on my car. The cars also on standard 16inch alloys. Hope this helps

 

[Icecavern]

Thanks, I'll check against mine tomorrow

 

[Fl@pper]

32cm on mine

eibach springs and upped a profile on tyres (feckin potholes)

 

[Icecavern]

Are you sure that's not 32cm mate 32mm is pretty damn low

Just measured mine this morning, 30cm so it's been dropped 50mm

 

[andyj]

reckon it'll go another 20mm easily

 

[Icecavern]

Not without first removing the arch liners it wont