As title. I bought a Golf mk4 one in the hope I could get it to fit. It looks totally different though. So can a few people post pics of theirs please.
The S3 on is a direct fit but you do need to cut a small amount of metal ou of it to allow it to fit around the passangers side bonnet lifter
I have a Sparco one - will post pics when I can.
Direct fit, no rubbing on the engine cover like some
Direct fit, no rubbing on the engine cover like some
i wouldn't have thought the golf one would fit as the leon as a A3 front end and golf rear.
So my first guess would be that there would be differences
So my first guess would be that there would be differences
Cupraloon
Guest
packageman23
Guest
Cupraloon
Guest
Bit of a guide here Clicky, clicky -->http://www.seatcupra.net/forums/showthread.php?t=133999
I used 10x25mm cap heads, i'd also recommend you get 2 nerw drill the ones i used were from homebase the "bullet" type a 5mm and a 10mm, as they have a starter bit on the end, and there easy to centralise the bigger drill once you've drilleda 5mm pilot hole...
I used 10x25mm cap heads, i'd also recommend you get 2 nerw drill the ones i used were from homebase the "bullet" type a 5mm and a 10mm, as they have a starter bit on the end, and there easy to centralise the bigger drill once you've drilleda 5mm pilot hole...
Last edited by a moderator:
Cupraloon
Guest
Funnily enough i was asked that before so heres a pic I prepared earlier in true blue peter fashion...
I filed it flat for about 30mm along the edge where the yellow ring is highlighted, then gave it a coat of satin black
I filed it flat for about 30mm along the edge where the yellow ring is highlighted, then gave it a coat of satin black
Similar threads
