-
Guest, 🎅🎄Looking for a stocking filler idea? Why not treat yourself or a loved one to our high quality CUPRA or SEAT valve caps. Order now from the merchandise store
Dump Valve help
- Thread starter cupra_poolie
- Start date
I have the induction kit that takes the cone down near the front bumper and the difference in sound is huge even changing at low revs.
If you do put your foot down the 'wwooosshhh' when changing gear or taking your foot of pedal is very loud in and outside the car.
Only problem is im a bit paranoid about getting water sucked up so im always dodging puddles
If you do put your foot down the 'wwooosshhh' when changing gear or taking your foot of pedal is very loud in and outside the car.
Only problem is im a bit paranoid about getting water sucked up so im always dodging puddles
Only problem is im a bit paranoid about getting water sucked up so im always dodging puddles
The joys of fitting a straw to your air intake lol.
think i might join you on the 007p and induction kit. ive got a gfb 50/50 hybrid blow off valve on there at the mo loud as ought on low revs and high with no ecu errors but unfortunately my car is remapped and after reading a few threads the cars remap dont like it (getting a lot of turbo stall)
Take the bonnet lining off, I read it on here and thought it wouldn't make much difference but it really does. My friend drove mine the other day and I could hear the standard DV whoosh from 20-30m away quite clearly and that is just with a green open cone filter and the bonnet lining removed, before I took the lining off you could hardly hear it at all
sounds like a good idea wouldnt it fade the paint after a while tho with all the heat from the engine going straight thru the bonnet ?
also with the cold side relocation it will be a lot louder with the valve being closer to the front grill. i think?
i've done the following...
...removed bonnet lining, forge coldside kit, removed my green dynatwist heatshield to create an open cone filter and from the inside it sounds just like my old 620ti atmos DV
(except i didn't get the bang, pop, and clouds of smoke afterwards
)
oh, and a remap should increase noise too.
...removed bonnet lining, forge coldside kit, removed my green dynatwist heatshield to create an open cone filter and from the inside it sounds just like my old 620ti atmos DV
(except i didn't get the bang, pop, and clouds of smoke afterwards
)oh, and a remap should increase noise too.
Mine has been on backwards for as long as I can remember with no problems. Forge even say you can run in backwards too.
Hi, i just purchased a 007p but it didnt come with any washer plates so i fitted it without them with green spring as i am standard map. Do i need the washer plate with the spring because it drives fine?
My 007 in reverse sounded quieter & the car felt more hesitant. I won't be running it like that again.
Where can you pick up induction kits that fit near the bumper?
Where can you pick up induction kits that fit near the bumper?
Similar threads
