lc boost to 22.4psi is it 2 high

[wezy0]

i have just done the n249 bypass. i know it should boost harder.
but its boosting two 22.4.it auq stage 1 map.with stage 2 mods.that on liquied gauge.

 

[sambryant]

are you sure its not stage 2 mapped?

 

[seatcupramad23]

not really , mine boost 1.5bar on stage1 which is the same

 

[wezy0]

are you sure its not stage 2 mapped?

i only hade stage 1 at the time coz i didnt have stage 2 mods
i had it mapped about 2 years ago was boosting 2 21psi then i put intercooler on then went down 2 20 psi an now 22.4psi

 

[wezy0]

mods stage 1 map is 3"down pipe 100cell race cat.2.27mm cat back.
fogre with yellow spring
green panel filter
silicone tip
siliecone boost pipes
bigger side intercooler
new n75f
new maf
cheers

 

[Rocky Rocastle]

22.4 on a stock lc tubby, is that genuinely safe level, just going of the responses above. Sure my stage 1 only runs 16 and always has.

 

[sambryant]

not really , mine boost 1.5bar on stage1 which is the same

thats more than me on a stage 2 lcr

 

[Rocky Rocastle]

Thats what i thought, my mapped lcr used to spike 22ish and hold circa 20

 

[rsmith]

thats more than me on a stage 2 lcr

No it's not.

 

[sambryant]

No it's not.

Im running 1.4 but thats on a mbc

 

[Rocky Rocastle]

to the intial question though as I'd be interested to know, is that sort of figure too high or not?

 

[wezy0]

Same mate.it boosting 22.4. Then holds 18psi.don't want to go bang.lol

 

[seatcupramad23]

thats more than me on a stage 2 lcr

well it use run 1.3 with standard airbox on it but runs 1.5 bar now with jetex open cone filter, i'm assure it safe to run 1.5bar but i guess your never might boom lol

 

[seatcupramad23]

thats more than me on a stage 2 lcr

Same mate.it boosting 22.4. Then holds 18psi.don't want to go bang.lol

it won't mate

 

[wezy0]

Hope not lol

 

[aaronipswich]

Wow my lcr peaks at 21.8psi with my forge with yellow spring
Which is alot better than my baileys 20.4psi I'm stage 1 mapped