Hi everyone,
I’m also planning to retrofit a heated steering wheel and came across this forum while researching the topic. I’ve already been in contact with Slavixs via private messages, who has been helping me with this project – thanks a lot for that!
After reading through the whole thread, I felt ready do go for the retrofit.
Today I wanted to carry out the retrofit, but unfortunately I had to abandon the installation because the connector on my wiring adapter wouldn’t clip into the fuse box.
I have a 2019 Seat Leon 5F 2.0 TSI with Kessy and all the available driver assistance systems. The production date is 17 October 2018 (so its 5Q0).
For the conversion to 5Q1, I purchased the following parts:
Steering wheel: 5FA 419 091 EPE
Steering column switch: 5Q1 953 513 EA
Clock spring: 5Q1 953 549 F
Airbag: 5FA 880 201 BD
Wiring adapter from AliExpress:
Adapter (5Q1 version)
I’ve read through the entire thread and, thanks to Slavixs'
help, I understand that I need to repin some of the connections.
As mentioned above, unfortunately I had to abort the installation today because I couldn’t insert the pin from the wiring adapter into the fuse box.
The fuse itself fits and locks into place when inserted, but the pin from the wiring adapter simply won’t fit into the fuse box.
So I have two questions:
1. Which type of pins fit into the fuse box?
I’m planning to use a small 10A fuse, either in slot 20 or in the top-left position (I believe that’s 1FA). Both of these slots are currently unused and have a permanent positive supply.
Could anyone provide me with a link or part number for the correct pins? Also an Amazon link or so would
help.
2. I’m not entirely sure where exactly I need to tap into the LIN signal from BCM connector T73C/54.
Where exactly is this connector located, and which pin do I need to insert the wire into? Does anyone perhaps have a photo showing the correct location?
I expected the connector be on the left hand side of the fuse box, but I didn´t see anything. Also I could not image to pin something, as its very very small space for working.
Working on the fuse box is really quite tricky due to the very limited space, so I’d really appreciate any
help or advice.
Many thanks in advance!