arb

Noticed a few noises coming from under meh car the past week or so, so got the underside checked out. Mechanic bent heat sheild back and stated that the front ARB linkage is failing but should be good for a while, with that and being in a rush I went on my way.... however, can some one...

I had my front neuspeed anti roll bar fitted last week, and had a nasty rubbing/knocking noise coming fro the front ever since. I thought it was just the arb needing to be worn in a bit, but a mate suggested its rubbing on the driveshaft? Going to take it back down to the guys who fitted it...

ARB question mk2 ibiza + bushes i know everyone (pretty much) has a neuspeed setup and are happy with it, running 25mm front and 28mm on back. i was just wondering if this one would fit? from venom motorsport? click my car is very low and im getting some handling problems now, dont wanna put...

Since lowering my car on Weitech springs & shocks, i've gone through two sets of anti roll bars at the front, the lower suspension just seems to put too much strain on the bolts holding them on to the point where they get so loose they knock, and the bolts just don't bite when trying to tighten...

Rear Strut brace :whistle:Before i get shouted at i have searched but could not find the answer to my question, which is is the only rear strut brace for the Leon the one that goes in the boot or is there a lower one that fits under the car, it just that i thought i saw one but i might be...

Just got the car back, took my guy bloody ages, front was a right ballache. Had to drop the front subframe out to get it in. Pulled into the garage to see the big red bars showing through the rims, looks [B)] Not so noticeable so much in the pics but they are chunky mofos, weigh a tonne...

hey folks just wondering if you need to drop either of the subframes/axels to fit a front and rear neuspeed anti roll bar.just got the suspension off just now so i thought i might aswell do it at the same time. owen:help:

been looking into getting a rear arb and have done a few searches, dose anyone know what the difference is between the golf mk2 setup with badgers bills L brackets or awsome gti's neuspeed ibiza ones. also do you need L brackets for the ones awsome gti sells:confused:

What can i say this lot has totally transformed my car and bank balance!!! This has all gone on my CUPRA TDI and i can safely say that this is money well spent, the clutch has taken some getting used to but no more slipping, its quite a shock how much the dog bone mount does! and then the...

Been a while since I last posted, so lots too tell! Car still going ace with no probs. Have recently read article posted on SCN regarding ARB's and was interested. Recently purchased and fitted front and rear Neuspeed ARB's, 28mm at the rear and 25mm at the front. What a terrific difference...

Have been reading around, and it seams the Eibach ARB's dont fit the LCR with a standard back box on as it rubs. Has anyone tried these with a blueflame system on, and does it allow that little extra to let the rear ARB clear the back box???

Lower strutt brace on the LCR I have read through loads of posts and Ruds sticky but cannot see a definiative answer:confused::headhurt: Are the Lower front strutt brace of the LCR and S3 different ie is the S3 one an upgrade for the LCR? If so is it a straight bolt on? Cheers...

Think Im buying a VRS arb off a member on here wondering how I go about fitting this arb. Is it a job I can do? and if so how do I do it, im alright when it coems 2 this sort of thing but not like massively confident so if its an easy job wouldnt mind giving it a go. Chears for any help

I am going to fit the VRS rear ARB to my 06 Ibiza FR. Can this be fitted locally or should I let Jabbasport do it? Is it a difficult job?

There is a rattle coming from the front drivers side of my wifes Alhambra. I think its the ARB bushes or the end link? Not too sure but GSF have the links for £9.50 ea but do not stock the bushes. Is it more likely to be the links?

For anyone curious to see what these look like off the car! The front of the car would be towards the wall. Note the dogbone mount sticking forwards in the middle, with S3 lower brace running beneath it. A ball joint bolts to the outer end of each wishbone and the joint fixes to the bottom...

I posted a few weeks ago about the standard backbox on my LCR hitting the rear Eibach anti-roll bar. Despite having the backbox bashed/welded a little to make more clearance (about 2" now) it is still hitting off the ARB when going over large bumps. I think the only solution to this is to buy...

Ive just got into work so dont really have time for a search, but need a part number for the above item! The Skoda garage couldnt seem to find a ARB for the vRS!? Aswell as telling me it wouldnt fit my MK4 FR TDi?! Cheers in advance peeps.

Incase anyone is wondering there is a groupbuy on the birskoda forum at the mo for a Jabba rear ARB, its gonna be £190 delivered, which is a fair old saving on the normal price. Just needing 3 more to meet the minimum of 10 people. I'm getting one for my Polo GTI, though maybe it would...

just fitted the 28mm neuspeed rear arb to my lcr and was just wonderin wat was the best hole 2 put the droplink in.i have it in the hole closest to the front of the car.is this the stiffest??cheers