asap

hi, i haven't done this in a while but here goes! i have a kenwood kvt725dvd pop out screen unit.it wrks fine but now i want to add to it.this is what i want: 2xripspeed 7"headrest screens bluetooth handfree kit video ipod link into my arm rest play station for the lad as for the rear...

i have a mk3 ibiza (drums on the rear), i needed to change the pads and give it a good clean out as they where sticking and not feeling very good. well i needed to get the air out the system as my break felt a little spongy. i loosened off the bolt to bleed the air out of the drivers side...

Right guy i'm really pissed off as car is booked in for mapping on monday 24th sept. An i fitted my new brembo's but they didnt come with the L shape banjo thing that the brake hose bolts onto. So they were rusted to fook so i WD40'ed them an tried to undo them an guess what they snapped...

can anyone tell me how long a garage takes to fit a clutch, think i may ned one in my 05 leon ft tdi with only 10k on the clock...

I've just had my windscreen replaced my a mobile fitter and to me it doesn't look like it's fitted properly. The strips of black rubber along the sides of the screen don't seem to fit flush to the screen. Here's a cross-section on how it looks now: As you can see the black rubber seal...

ok folks i have a 51 plate 1.9 tdi ibiza the car keeps getting to certain revs then not going any further which i beleive is called limp mode, i have replaced the maf sensor but its till doing the same any ideas?

I need to get the hoses made up for my brakes, so i need to know the following... Length of hoses. Fitting on the other end to the caliper. I know the calipers take 1/8npt on the inlet i need to know the other end. Thanks.

In the middle of putting on my Colour Coded Door Handle's Passenger side is on and omg what a difference!:D Any drivers side is more harder I know that the cable is under the electric window switch, I cant get that small panel off as there;s something tight holding it down and i dont...

Oh Crud! Need new Pads/Disks ASAP! :help: Its coming up to my yearly service on my LC and it was stated last year that the Disk pads had about 5k miles worth left before needing changing. So been looking to get this done but it looked like there was quite a bit of meat left on the pads so...

HI All gunna service the DV tomorrow but want to clean the carbonio kit as have not really looked at it since i have bought the car I believe the filter is the same as a green panel like filter (all be it a cone shape though)? Can i use the standard green filter cleaning stuff? need to...

my drivers side driveshaft went lastnight so am a bit peed off. do the driveshafts from the 2.0 8v fit the 1.6 8v? and is there any difference in size/casing of the gearbox? im asking coz i can get the gearbox and driveshafts from the 2.0 8v cheaper than the 1.6 8v.

just fitted my laguna fmic have had it runnin ok for two weeks now i have a boost problem, put my foot down boost gauge gows to 1.3 bar very well and boosts as normal, holds the boost for like three seconds then looses all the pressure reads 0 bar with foot flat and runs like a bag of ****. ive...

Hello... i need to change my brake fluid asap... i think it's nearly empty... I bought some DOT4 Castrol Brake Fluid from the supermarket today and i need advice on how to change it. What should i watch out for ? Do i need to empty the old fluid and put in the new one; or simply add the...

need a little help just about to replace the two grills between the s badge, ordered the new part which has now come ...(think its something like radiator panel) how do i get the old one of as it seems to be attached by some sort of plastic welds to the bumper and is there any screws ...

Need advice ASAP regarding exhaust fitting Hello all sorry to bring this up from the depths, but quick fit have decided to replace my whole exhaust D/P all the way back including the cat! free of charge mind you. well my problem is they want to remove the front subframe :blink: as the...

Please can somebody help as my engine management came on tonight and i ran vagcom and it came up with 2 fault codes 17511 P1103 O2 Sensor Heating Circ.,Bank1-Sensor1 Output too Low 17524 P1116 O2 Sensor Heater Circ.,Bank1-Sensor1 Open after resetting the faults 1 fault reappear again...

:( Can someone point me in the best direction of where to get an Uprated clutch / VR6 Flywheel and to have it fitted please, its now slippping whenever Im on full boost with the boost controller turned up. I live in Dover, Kent, so the nearer to me the better. Any help would be appreciated. Cheers

hi every one i spoke to gsf car parts today about getting a new maff housing and sensor the one i need is for a leon cupra r gsf told me there is a couple of diffrent ones to chose from so what i need is the part number for the one i need my car is a seat ibiza cupra turbo 2001 reg i am...

Hi every one i ordered some top mounts for my mk3 seat ibiza cupra 1.8 20v turbo i ordered from GSF car parts they sent a set but they're wrong now they tell me they dont sell them but i remember someone saying on here that they got there top mounts from GSF car parts so does any one have a...

Got an orange warning light on, top right, its like a box with two wires coming out of it, any ideas? can anyone get a pic of the engine warning lights? thanks