failed

Hi All, I have just had the dreaded conrod failure on the 1.9 TDI BXE engine in my 2008 Leon. No warnings or anything, just a sudden breakdown on the Motorway. I do want to get this back on the road as I've put a lot of work into the car so I know all other aspects of it are sweet. Just...

As above guys failed my mot today on high exhaust emissions... still not past yet They tryed replaceing the afr regulator never made a diffrance, lambdas are reading fine. Garage ran out of ideas, i only have a cat-back exhaust and the cat is looking a bit iffy so could the cat be fooked...

I failed my MOT today on my 04 LCR It failed on emissions, the results where FAST IDLE CO: 1.174 MAX 0.3 FAIL HC: 106 MAX 200 PASS LAMBDA: 0.972 0.970-1.030 PASS 2ND FAST IDLE CO: 0.817 MAX 0.3 FAIL HC: 151 MAX 200 PASS LAMBDA: 0.971 0.970-1.030...

Hi guys (and girls), I've seen a lot of nice cars up here and thought I'll put my boy up as well. I'm not gonna bother you with the story of the car (it's quite interesting though). Let's get down to business :clap: MODS: Engine: - 2.0T Engine Conversion - came out of...

November I had a coil pack go (cyl3), then just before Christmas I had another go (cyl2). Cylinder 3 was replaced by a garage Cylinder 1/2/4 I replaced, with generic coil packs off ebay (Lemark CP003 on the box, and 081201BA on the coil pack itself). Probably done 600 miles or so since...

i have the remote key with 2 buttons on it if you push either one of the buttons the red light will flash on and off if you keep your finger on it ....BUT it wont open or lock the door can anyone help please

On my last service it was pulled up that the inner seal on the tandem pump was letting oil into the fuel filter. The garage that carried out the service quoted 115 pounds to replace the seal, where as the local seat deal has said that seal cannot be replaced and that a new pump is require at...

Yesterday my wife's 1999 1.8 20V failed it's MOT on these main points: - NSR brake caliper leaking - NSR coil spring incomplete - NSF lower suspension arm rubber bush deteriorated My questions are: I'm going to have a look at the caliper, hopefully can replace the seals or...

Hello folks.. My fan blower switch has stopped working on positions 1, 2 and 3...Do i have some failed resistors here?? Thanks in advance folks..

Coolant alarm has been going off every now and again now for about a month so i have been topping up the coolant, then yesterday the temp sensor went up to 120 so i pulled over had a look and noticed that i had more coolant in the expansion tank than when i started. I have had a look this...

Just a quick posting here, hopefully it will be of use to someone. For a while now the car has been 'pinking', even with super unleaded fuel. I put it down to old spark plugs, as it was due for a service. So I swapped them out, but the pinking remained. Then last night it got really bad, it...

Car just failed its MOT :( got a bit of a list going on. The only point I'm not so sure about is the excessive free play at the steering wheel, it seems to be from the clamp that connects the steering wheel rack to the steering, it seems to be lose. I need to check with seat they gave me the...

Last week i had to take the Leon down for its MOT, Its passed every year with the same Piper exhaust with the sports cat but this year its failed because its to loud:wtf:!!. What a pain in the arse, When did this come change in the mot come in? Does anyone have a standard system that i may...

What lights will be up on dash, and any other signs? as i think mine has died, its a 210 Amk LCR

out and about this evening, rear wheel bearing failed. question is do i need a Press to refit these or will i be able to "tap" them back in :shrug:

Hey! My 05 reg (27k miles) failed it's mot today due to a snapped OEM exhaust mount (rear section)! Looking at the backbox it has sagged slightly but isn't loose! How easy is this to fix without buying a brand new section (£270 from seat)? Is this a common fault? Retest a week...

right here is what it failed on 1) Front brake hoses no place to clip in hoses (brembo 305mm setup with braided hoses) what can i do about that? 2) rear brake pads very low (are the EBC ultimax ok for rear seeing as they are £20 ) 3) cv boot not sucure to housing (needs cable tie) 4)...

Hi my LCR failed its mot due to emmisions being a tad to high the mot man said the lambada sensor would need changing , altho id would of expected vag com to have been reporting it? - but i bought one any way , is there anything else its could be before i go for a re-test??

Im new here so here we go , took my 1996 ibiza 1.4 for an mot the other day and it failed on the emissions. I changed the spark plugs and HT leads, as the car had a slight misfire anyway, it runs loads better now and feels better to drive, but took it back for the retest and its failed again...

i have a leon cupra on an "X" plate, ive searched the forums and found the common issues with the master cylinder. i was driving this morning, went to change gear, and clutch pedal stayed on the floor, wouldnt even come back up when i pulled it. i need a new clutch pedal anyway as the rod...