1.4i fresh off the rollers got.....

[surcalation]

....67.5bhp & 85.1lbft Torque

Not bad really. Car only has exhaust modification and I was advised that my car is running lean and could ideally do with a bit more fuel.

Any idea's why it could be running lean? Would if be worth fitting an FSE powerboost valve to increase the fuel even tho it's only going give 1-2bhp. Priced it up at £90 + fitting.

At that figure I thought the rollers where being generous as my last go was in my old ibiza and that got 63bhp BUT it had a large jap canned exhaust on it, and the engine was in a lot worse condition.

I will not be fitting an induction kit to it! But I might increase the cold air flow with some nice DIY shop's tumble dryer style hosing

 

[m0rk]

it's a bit low. SPT gave my old 1.4 73bhp, F2-Stu was north of that without FSE, but he did get one plumbed in & dyno tuned and it did yield a little more.

 

[surcalation]

That's with standard airbox mind?

Any idea on the under fueling tho?

SPT did rule tbf lol

 

[Brummy]

Chrissy, sod the tumble drier hose..get y'self down to your local DIY shed and get some of the heavy duty stuff only cost me a fiver for a great chunk of it when I had my Red-Shed..

 

[MarkJ]

Where did you get it done mate? Saw you this morning BTW, about 8:15 on my way to work.

 

[surcalation]

Was done at Noble Motorsport in Chesterfield

Yep you would of seen me in convoy with the rest of the lads

 

[chris285]

sounds pretty respectable, all i would get is a blown engine for a guess with a likely faulty head gasket atm

 

[F2 Ed]

Don't get an FSE, there is much better adjustable regulators on the market.

My old ABD ran lean with induction and exhaust so i put a bigger fuel injector in there. Then it ran rich and poped at high rpm lol