Well I have the ECP, and engine management light on at the moment.
I figured I need to do a throttle rest, so whipped out the old vag com and did the following:
Turn on ignition to stage one
open engine controller
mesuring blocks - 08
block 060 and hit go
click basic settings
wait while it resets
click back to measuring blocks.
I have two queiries.
1. Even after I have done the rest, the ECP and engine light remain.
2. When the pedel is fully depressed, it only reads as 85.2%!
I have tried everything to fix both of these, yet cannot seem to sort it.
Any ideas?
Thanks guys,
Matt
I figured I need to do a throttle rest, so whipped out the old vag com and did the following:
Turn on ignition to stage one
open engine controller
mesuring blocks - 08
block 060 and hit go
click basic settings
wait while it resets
click back to measuring blocks.
I have two queiries.
1. Even after I have done the rest, the ECP and engine light remain.
2. When the pedel is fully depressed, it only reads as 85.2%!
I have tried everything to fix both of these, yet cannot seem to sort it.
Any ideas?
Thanks guys,
Matt