boost problems

[mini_hammy]

well after few people telling me its prob my n75 valve a replaced it with no sucess


so a was looking at my n249 and n122 (whatever its call) and that wee black and white thing (whatever thats called too) lol

and a have done the bypass but one of the plactic bits on the n249 and the other seem to have melted and the wee black and white thing looks like it has too ..... can this be causing my boost spikes and limp mode??

cheers for any help thanks?

stu

 

[s1l3nc3r]

Could be.

If its causing a boost leak then it will cause problems.

You throwing up any codes on vag-com.?

 

[mini_hammy]

last time a check about a week ago it was

17963 and 16795

which is charge pressure and secondry air injection a think

 

[RabReith89]

If its the N122 valve that melted just solder a resistor on it, i used a 330 ohm 3 watt and that should do the trick mate.

I dont use the wee black and white thing.

Rab

 

[mini_hammy]

Could you send a pic of your engine bay so a can see fella??