=jsy= $H466Y
Guest
Having recently changed my master cylinder and subsequently having to replace the primary brake pipe to the ABS modulator, then bleeding all brakes until there is no air at all coming out using both an Eezibleed kit and the conventional 2 person method - I took the car for a drive at all speeds and am getting nothing but a spongy brake pedal. The pedal is fine when pumped a couple of times initially but if pumped and held down the pedal goes to the floor with a little force. I drove down a country road with no other cars about at approx 50mph and slammed on the brakes hard and it emergency stopped with no problem. As the brake pedal goes to the floor and its only the last bit that really makes any difference it was pulling to the right a very small amount for this small time. I thought this would be down to one brake having air left in so I rebled the brakes but to no avail. Any ideas.