Brake servo hose

[Robbie C]

I'm looking to replace the 90 degree elbow that comes off of the inlet manifold and onto the brake servo hose which I'm led to believe is 12mm but Forge only list 11 and 13mm elbows?

What has everyone else used to replace this? Is it ok to use a 13?

 

[Robbie C]

Just read a thread where DPJ said he ran 8mm without any issues so I've ordered 11mm

 

[Davem]

Maybe im thinking of wrong part but a 12mm straight bit would do it surely? Just bend it to the 90degree. Cheap on ebay.

 

[Robbie C]

It'd need to be vac hose to bend and wouldn't look as nice as a proper silicone elbow imo