g22-vss

[Badger]

Have you got same error code?

 

[zare]

yes , the code and the problem is the same

 

[Badger]

I'll look on Elsawin tomorrow for wiring diagram.

 

[zare]

If you can find where go CAN high wire from cluster to ecu ( speed signal) .
I look Autodata , but scheme is bad .
And can you give a direct speed signal from cluster ( white/blue ) to ecu ( ecu pin/wire ?)

thanks

 

[Badger]

I'll see if it's listed.

 

[enz]

Hey, so I tried to log the 4 speed wheel sensor all the 4 sensor got the same speed as the speedometer, I tried to found some wire issue, can't find , it's so annoying

 

[Badger]

It'll be a link from either ABS to ECU or Cluster to ECU

 

[zare]

from Cluster to Ecu is bad link, becouse speedo work normally

 

[Badger]

Wiring pinouts

Cluster T32/7 = Canbus Low (Orange/Brown)
Cluster T32/8 = Canbus High (Orange/Black)

Connect via Bulkhead to ECU through white plug at Pins 6 (low) 9 (high)

It then joins the ECU at pins

T80/31 + T121/60 (High)
T80/32 + T121/58 (Low)

 

[zare]

thanks for information. Tomorrow i check this wire.

 

[zare]

Hi all .
in one service my problem is fix, the problem is one cable is cut in a bundle of cables before bulkhead.
exactly where one turns bundle cables cable interrupted bundle.

 

[zare]

thanks Badger for your advice.

 

[enz]

can't find it yet any one?. in vcds there is block 4 in engine that show the vss while am driving the block shows 0 and not the speed that the cluster show or the abs wheel sensor, I don't know where to go with it the mechanic
said he gave up