GTi splitter fitting help

[ScotlandToIbiza]

does the splitter just replace the part shown in the pic?

cheers

 

[myseatcupra]

i think you pull your old one off. and the gti one clips in its place

 

[ibiza1.4]

yup, thats right, this is a piece of piss to get off, the gti splitter dont like going on but if u have patience it will, took me like 5 mins, just dont get annoyed wen u do it hehe

 

[ScotlandToIbiza]

nice one should be a walk in the park then

 

[ibiza1.4]

good luck mate

 

[Smithy]

just the screws infront of the front wheels holding it on, then it'll clip off.

 

[ibiza1.4]

yh forgot to mention that, my bad

 

[ScotlandToIbiza]

done what a ******* I'l get a pic later! cheers for the help.

 

[ScotlandToIbiza]

much better

 

[ibiza1.4]

yh lookin good, mine got f***ed in my little run in wiv a push bike so the old standard one is back on

 

[Boi Ninja]

looking good mate, but looks to me it still needs pushing in (or might be the angle of picture) ...sitting down on the floor and using your feet, and hold the fog light cover bit thats what i done anyway.

 

[ibiza1.4]

yh, just noticed that aswell, needs a little push then itll be sweet

 

[ScotlandToIbiza]

I'l take a close up I'm sure its fine

 

[Mckellar]

tidier.
my leon splitter is due for renewal soon, chipped and scratched to f00k.

 

[CraigW]

How much bigger is the gti splitter?? I.e top to bottom.

Ive been thinking about one of these with an lcr splitter on it but the only issue is clearance as my car is lowered 60mm at the front and my town has speed bumps pretty much everywhere!?

 

[Roelích]

I don't expect my LCR splitter to last very long, but at 17 quid they're pretty disposable.

 

[Roelích]

I've done a search... Are there any guides on fitting the LCR splitter to a Mk2?

 

[Boi Ninja]

I've done a search... Are there any guides on fitting the LCR splitter to a Mk2?

i think i saw one on here wait ill try searching for it but i think they chopped an inch in the middle for it to fit on properly.

 

[Roelích]

Yeah, I know it takes some chopping to go on, but I've searched all over and can't find the guide. If it indeed exists.

 

[Czechboy]

Its straight forward to fit the LCR splitter onto the GTI spoiler. all you need is 10 little self tappers and a hacksaw. Offer the LCR splitter to the GTI one, then hold it in place using some duck tape. Next screw on using the self tappers and then chop off about 3cm from each end to make the ends flush with the bumper.

Job done should look like this:

Mig