The exhaust noise between 3/4k with the bluetooth cat turned off was awful so a resonator was definitely needed and the Vibrant Performance 1793 Res did the job perferctly
Oil temp sensor relocation from oil drain plug to it's own spot on a new oem oil pan
So turns out with very little exhaust back pressure it takes very little effort to make boost though 1.6-7 bar below 4k in THIRD is not how internal components stay INTERNAL.
Back on Unicorns roller today to redial in the boost control plus finally (after sleepless nights and internet rabbit holes by me) diagnose the n75 cut off
1st pull, no tuning changes....
265hp/256 tq
Confirms the mass flow logs
212.1g/s ÷ 0.8 gives 265hp (estimated)
I was happy....1 and done!! Take it off I'm going home
After some fine tuning of the boost control, fuel and timing we settled on some very nice looking curves and respectable numbers!!
258hp@6200/253ftlb@3600
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.