Yeh theyve sold a long time ago bud. enquired about them a few months back.
Cheers for the heads up though
Cheers for the heads up though
Guest, 🚨New Stock alert: Premium CUPRA valve caps now available in the store 👉 Order now from the merchandise store
When the moon turns red and the durka durka trees loose their leaves.....
Yeh theyve sold a long time ago bud. enquired about them a few months back.
Cheers for the heads up though
Nice one
Dude you coming to p torque at the end of the month?![]()
Looking good! Hows the handling holding up? I think a track day is in order![]()
Looks much better now Ash!
Sorry to ask a noob question...How do you know when it's level? do you have to count the threads on the strut?
looks sweet mate![]()
I hate door dings! got a couple on my car which really annoy me. If it's below the door moulding I don't reckon another car door could have done it (unless it was a caterham
)
I'd think it could have come from a trolley jack...
You could try the hairdryer and compressed air trick Ash that might work - worked a treat on my Polo a couple of years ago!![]()
looks like a paintless dent repair job i had a couple done on mne works a mirracle and you cant see how hard you look where it was!
Basically have a can of compressed air at the ready, warm up the dink slightly with a hair dryer so it goes warm and not too hot, then spray the compressed air straight on it.
Takes it from a point of heat, to a point of cold quickly and the reaction in the metal can pop out the dink ... it's a touch and go thing but it did work on my Polo!
http://www.youtube.com/watch?v=miNykNl-0NM
you can do what I'm gonna do and that's put a tape measure from the bottom of the wheel to the top of the wheel arch and measure the same all the way round.