LCR Mudflaps

[DannyC87]

As mentioned I have mudflaps on mine; they do help massively with keeping the car clean (mine is still filthy atm though!) and they make it look even lower!

 

[J0N]

My mudflaps, they're the Sparco universal ones from Halfraud's
and I'm really pleased with them. I think they match pretty well
especially with my anthracite wheels. Not the best pics but you'll
get the idea.

 

[jamiebennett81]

I do these, in red but they have been sitting on the shelf now for sometime.....swaying towards they will look chavvy and a bit OTT

 

[J0N]

TBH unless you're looking for them I don't think you really notice them on mine as they fit in really well with my colour scheme. I was just sick of cleaning off the winter salt and the summer tar and general crap thats all over our roads, the paint on the underneath of my side skirts is in a right old state and before I sort that out I thought I'd put some prevention in place first.

 

[Dyscontinued]

Speaking from a safety point and not aesthetics, I think they should be a legal requirement from the factory on all cars. Would make motorways in the wet a lot safer.

 

[wayne lcr]

TBH unless you're looking for them I don't think you really notice them on mine as they fit in really well with my colour scheme. I was just sick of cleaning off the winter salt and the summer tar and general crap thats all over our roads, the paint on the underneath of my side skirts is in a right old state and before I sort that out I thought I'd put some prevention in place first.

they luck good m8 and in same boat as you under side or my skirts r a mess geting them painted after the winter.i wounder if you could take the skirts off then fit then refit the skirts.to eleminate the bulg on the flap

 

[adam cupra 20vt]

Ohh they look same as mine Jon...prob because they are

Have you donr rear ones yet? I've not had good look at doing mine but from what I remember the inside of bumper/splashshield is not flat so will need a few washers to make it sit flush.

 

[J0N]

Ohh they look same as mine Jon...prob because they are

You know, .

Have you donr rear ones yet? I've not had good look at doing mine but from what I remember the inside of bumper/splashshield is not flat so will need a few washers to make it sit flush.

I have'nt done the rears yet but you're right, they won't sit flush and will need some sort of spacer/packing.

 

[adam cupra 20vt]

Did you make the front 2 out of 1 sheet so you can make the back 2 out of the other 1?

 

[J0N]

No, I used the full sheet to get maximum height and width and only cut bits off where the tyres were going to catch. Mine are quite low to the ground though.

 

[adam cupra 20vt]

Mine are quite low to but don't come up as far as yours hence I'll get 4 from 1 set............I'm tight as a ducks ass under water

 

[J0N]

My Brother would like you, he only breathes in!

 

[adam cupra 20vt]

My Brother would like you, he only breathes in!

PMSL ....yeah don't want to waste anything!

 

[J0N]

I have to admit that I've still got the cut-offs even though they're a bit small. You never know.......

 

[adam cupra 20vt]

Yeah to be honest I reckon you could do all 4 from one set pretty easily, the sheets are pretty big.