Nomad A pillar boost gauge fitting guide..

[freddy_t]

As the name suggests, does anyone know of a guide on how to fit these A pillar boost gauges? many thanks fred.

 

[PhilW]

Yeah, heres one.

Pull off the tabs or remove grab handle. Undo the screws. Rip out the old pillar.

Now do the opposite to fit it.

Now sit back and moan like **** to how **** it actually fits.

 

[smoothuk]

well easy to o just pull it off, i found my nomad one fits excellently, just use BOTH the strips of velcro that come with it....

 

[freddy_t]

ok, how about actually fitting the boost pipe etc? I hear you have to drill a hole in the engine bay, run the pipe around the front end and then push the pipe into a small green hole? I bought the item 2nd hand and therefore have no instructions! lol. many thanks fred.

 

[David_smith_909]

Yeah, heres one.

Pull off the tabs or remove grab handle. Undo the screws. Rip out the old pillar.

Now do the opposite to fit it.

Now sit back and moan like **** to how **** it actually fits.

they have been remoulded now, got mine about a month ago and the guy on the phone said the remould got done about 2 months ago because of all the complaints they were getting, mine seems to be ok

 

[David_smith_909]

ok, how about actually fitting the boost pipe etc? I hear you have to drill a hole in the engine bay, run the pipe around the front end and then push the pipe into a small green hole? I bought the item 2nd hand and therefore have no instructions! lol. many thanks fred.

dont need a hole, its already their

 

[smoothuk]

i shoved my pipe throught the rubber gromet where the bonnet release cable goes through the bulkhead....is tight but it goes....

 

[freddy_t]

Got it sorted, was extremely easy to fit! Ended up pusing the pipe through insulation directly behind A pillar and it came out next to the ecu! Sorted!