Random carbon box thing...

[jaypee]

I have no idea what this thing does, seems to run down to the fuel tank for gases? (circled pipe) and chucks em into the top of the engine via a relay kinda switch thing (arrow).

Can I remove this, it seems to be ok without it? Do I join the two pipes together or block them off (I assume joining them is probably not recommended).

Do I need a resistor?

I've had a look on here about this, but I got 101 different messages.

Thanks in advance

 

[chris_200120vt]

just removed mine last week easy way to do this is get a 330r 10w resistor chop plug off and follow hose that goes around the rocker cover back to the t piece and block it off job done as for the pipe you have circuled just run some hose down the wing if you need pics can post them up tomorrow

 

[jaypee]

Thanks for the quick reply! Sounds good! Will get that done tommorow. Where did you get the resistors? RS Components? 10w is a pritty big resistor!!!

 

[Robbie C]

I didn't think anyone had found a resistor that permanently stopped an EML yet?

 

[s1l3nc3r]

Thats what i was going to say...even with the resistor you can get an eml because the resistance fluctuates or somthing. Thing a way round it was to take the top off an leave the original plug on. Then disconnect and remove the rest of the system the same.

 

[Robbie C]

That's what I've done. I've extended the wires so I can hide in in the wiper scuttle, completely out of sight