-
Guest, 🚨New Stock alert: Premium CUPRA valve caps now available in the store 👉 Order now from the merchandise store
Because I want to keep my insurance down atm (Currently £213 Fully comp) Another 3 years and I'll have a clean licence again so will be on the lookout for a new shape Leon Cupra.
Few more pics
Engine bay before (With standard 1.4 airbox feed pipe)
Engine bay after fitting the airbox feed pipe extention (£70 from SEAT dealer) as fitted to 1.4 16v 2003 Leon's with Air Con.
Also got a K&N pannel filter fitted now
Bought a chrome vent kit a few days ago as well. Was quite cheap.
Few more pics
Engine bay before (With standard 1.4 airbox feed pipe)
Engine bay after fitting the airbox feed pipe extention (£70 from SEAT dealer) as fitted to 1.4 16v 2003 Leon's with Air Con.
Also got a K&N pannel filter fitted now
Bought a chrome vent kit a few days ago as well. Was quite cheap.
They're a custom job mate.
Here ya go matey
Chrome Vents
Give him an offer of £20 and he should accept it. Thats what he did mine for
Here ya go matey
Chrome Vents
Give him an offer of £20 and he should accept it. Thats what he did mine for
Rookwise, can i ask you a random question?
Where did you get the rubber mattings stuff you have around by your gear stick?
I want to get some but i don't know where to get it from!
Cheers!!
Where did you get the rubber mattings stuff you have around by your gear stick?
I want to get some but i don't know where to get it from!
Cheers!!
Not done much in the last few weeks except to remove the outer chrome grill trims and fit an Audi A3/S3 lower strut brace.
Took the rear badges off as well (again)
Pics
Took the rear badges off as well (again)
Pics
Its a hand made one mate
I contacted the Ebay seller hot.gaiter to do mine. They do very good custom made bits. Had a few off them before.
Depends how you are going to fit it. To the original plastic holder (after undoing the staples holding the standard gaiter on. Quick and easy route) or if your going to what I've done and fit an alloy gear surround.
If you do what I've done. The surround will cost you £40 from Richbrook. There are cheaper ones found on Ebay though. Then get some welding rod and bend it to the shape of the alloy surround. Fit the gaiter to the gear knob and then fit to the gear column. Slide the alloy surround down over the gaiter. Then put the ends of the gaiter to the underside of the alloy surround. The welding rod then does inside the bottom of the gaiter so that it stays the same shape as the surround . Fix the surround down with screws and all done.
15-20 mins job max.
I contacted the Ebay seller hot.gaiter to do mine. They do very good custom made bits. Had a few off them before.
Depends how you are going to fit it. To the original plastic holder (after undoing the staples holding the standard gaiter on. Quick and easy route) or if your going to what I've done and fit an alloy gear surround.
If you do what I've done. The surround will cost you £40 from Richbrook. There are cheaper ones found on Ebay though. Then get some welding rod and bend it to the shape of the alloy surround. Fit the gaiter to the gear knob and then fit to the gear column. Slide the alloy surround down over the gaiter. Then put the ends of the gaiter to the underside of the alloy surround. The welding rod then does inside the bottom of the gaiter so that it stays the same shape as the surround . Fix the surround down with screws and all done.
15-20 mins job max.
i would not bother they dont work.
car is looking well andy will c u at the meet
don't forget it your turn to get the glass of chocolate ice cream in
Cheers mate
Just fitted a set of S3 chrome mirrors to the Leon (Full replacements. Not crappy stick on jobbies)
Not too sure about them atm but at £78 I think they will be staying on for a bit.
Just fitted a set of S3 chrome mirrors to the Leon (Full replacements. Not crappy stick on jobbies)
Not too sure about them atm but at £78 I think they will be staying on for a bit.
Cheers.
I saw the chrome covers for the facelift Leon at my SEAT dealer and liked them. Was gonna do a full swap and change to teardrop mirrors but they would have cost me £368 and then the teardrop covers £48.99 so turned out to be expensive.
Gave up till I came across these. Apparently to get them from Audi you have to prove you have an S3 and the covers are in the 3 figure mark. Got mine from Germany and also has the signature in pen of the person who made them written on the inside of the cover.
I saw the chrome covers for the facelift Leon at my SEAT dealer and liked them. Was gonna do a full swap and change to teardrop mirrors but they would have cost me £368 and then the teardrop covers £48.99 so turned out to be expensive.
Gave up till I came across these. Apparently to get them from Audi you have to prove you have an S3 and the covers are in the 3 figure mark. Got mine from Germany and also has the signature in pen of the person who made them written on the inside of the cover.
My brother-in-law has got a 03 plate 1.4 leon and its a very nice car for what it is and for the price he paid for it. Can't understand why you are spending so much on that car when it could go towards your next car unless you are thinking of taking the bits of it when you come to selling it.
Not done anything on my car lately due to moving house again.
Only things I've done are:
KVW 100 Auto Windows
Teardrop Mirrors (Bargin off Ebay in mint condition for £35 delivered)
56 Ibiza FR Matt Silver Teardrop mirror covers.
Saving me money for VWNW. Want some shiney bits for the dash
KVW 100 Video
http://smg.photobucket.com/albums/v437/Staz081277/Other Stuff/?action=view¤t=MOV00044.flv
Pics
Only things I've done are:
KVW 100 Auto Windows
Teardrop Mirrors (Bargin off Ebay in mint condition for £35 delivered)
56 Ibiza FR Matt Silver Teardrop mirror covers.
Saving me money for VWNW. Want some shiney bits for the dash
KVW 100 Video
http://smg.photobucket.com/albums/v437/Staz081277/Other Stuff/?action=view¤t=MOV00044.flv
Pics
Similar threads
