Scan errors after retrofit on Leon mk3

[George_TGC]

Helo o all,

I am asking for your help for solving this problems I currenly have.
I made 2 changes to my car and now I have new errors for which I cannot find solutions on the net.

1. I added led footwell lights so this error is permanent:

0531 - Footwell Illumination
B11FF 01 [009] - Electrical Failure
Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 6
Fault Frequency: 1
Reset counter: 25
Mileage: 204566 km
Date: 2024.01.21
Time: 15:07:41

Terminal 15 status: On
Terminal 50 status: OFF
CAN-Bus_aktiv: On
Status Bremslichtschalter (HW): OFF
Status Bremslichtschalter (CAN): OFF
OFF: operated
Position lamps: Not operated
Automatic high beam assist: Not operated
Low beam: Not operated
Parking light left: Not operated
Parking light right: Not operated
last_wakeup: no cause for fault protection
Voltage: 11.7 V
Outside temperature: -2.5 C

2. I added reversing camera

131689 - Rear View Camera System Control Module
U104C 00 [008] - No communication
Intermittent - Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 2
Fault Frequency: 1
Reset counter: 65
Mileage: 204572 km
Date: 2024.01.21
Time: 15:20:43

Terminal 30 power supply: 13.2 V
Terminal 15: OFF

10489856 - No Basic Setting
B2010 00 [009] - -
Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 5
Fault Frequency: 1
Reset counter: 25
Mileage: 204566 km
Date: 2000.00.00
Time: 00:00:00

OFF

13705478 - Databus
U1121 00 [009] - Missing Message
[New feature! Extended UDS fault detail is only supported by current gen. interfaces]
Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 6
Fault Frequency: 1
Reset counter: 25
Mileage: 204572 km
Date: 2024.01.21
Time: 15:20:50

passive

I know that for 'No basic setting' i need ODIS, but for the other error I cannot find solutions on the net.

 

[LeylandVCDS]

No basic settings on the camera means that it is not calibrated. It works fine without calibration, just leave the error as it isn't coming to any harm

Footwell light coding here - please see later post if the slider control in the infotainment screen doesn't work
Coding for footwell light retrofit

If you have fitted LED footwell lights, please see this to eliminate the error of the LED lamps on the footrest panels All models
If you are thinking about putting LEDs on the footrest soffits, with this modification you will avoid the VCDS footwell light error.
1 - Module 09 - Electronic control unit. Code (31347)
2 - Adaptation
3 - Leuchte30FR LC72
4 - Lasttyp 30 - (Change value to Led Kleinleistung - Default 2 * 5W)