• Evo Magazine are looking for a mint and (and ideally unmodified) Leon Cupra Sub8 to drive and photograph for a feature. Find out more here .
  • Hey Guest👍👎 We're looking for reviews of your local CUPRA or SEAT Dealership - it's quick and easy to do: Leave a review now
Mar 10, 2025
15
0
Hello All,
Ive had these error codes come up on my Seat leon Fr 1.5 2020 and not too sure what could be causing them.

I origionally thought they came up due to needing to replace the battery (as it was low) but i have done that and they're still there.

The errors did clear after driving down the motorway for 30 minutes but came back on once i came to a full stop on the sliproad.

Ive tried clearing them with an obd reader but they clear and then come staight back up.

My only other thought is if there is a fault with the parking break itself which is causing the error codes although the parking break is holding fine, so not sure if it just needs adjusting. Or if theres a relay issue.
 

Attachments

  • seat 1.png
    seat 1.png
    48.7 KB · Views: 336
  • seat 2.png
    seat 2.png
    65.8 KB · Views: 265
  • seat3.png
    seat3.png
    77 KB · Views: 293
completely speculative and from experience, a defective battery. But as already mentioned, an autoscan brings more light into the dark
 
1741878320130.png



Hello all just wondering where abouts Number 2 component is located. Any pictures would be helpful.

Thank you
 
Hello All,
Ive had these error codes come up on my Seat leon Fr 1.5 2020 and not too sure what could be causing them.

I origionally thought they came up due to needing to replace the battery (as it was low) but i have done that and they're still there.

The errors did clear after driving down the motorway for 30 minutes but came back on once i came to a full stop on the sliproad.

Ive tried clearing them with an obd reader but they clear and then come staight back up.

My only other thought is if there is a fault with the parking break itself which is causing the error codes although the parking break is holding fine, so not sure if it just needs adjusting. Or if theres a relay issue.

I'm also looking for a solution to this problem. Did you find any?